TUBE-UPPER 2B3795 - Caterpillar

Fig 3.40* Press Select Mode key* Press 3 key* Press 9 key* Press ENTER keyThe Special Test screen (Fig 3.40) is displayed.The special test can not be started while the engine is running.Connect the special test harness 'A' connector.Press ALT1 to start the special test.
Fig 3.41The Special Test 'A' In Progress screen (Fig 3.41) will display while the special test 'A' is in progress.
Fig 3.42The Special Test Disconnect 'A', Connect 'B' screen (Fig 3.42) will display when the special test 'A' is completed. This is to inform the user to disconnect special test harness 'A' connector and connect the 'B' connector.The connection of special test harness 'B' connector must be made within 5 minutes from the initial displaying of the special test disconnect screen (Fig 3.42).
Fig 3.43The Special Test 'B' In Progress screen (Fig 3.43) will display while the special test 'B' is in progress.
Fig 3.44The Special Test Passed screen (Fig 3.44) will display when the special test is completed and passed successfully.Press ALT1 key to reset the test and go to the Special Test screen (Fig 3.40).
Fig 3.45The Special Test Fault screen (Fig 3.45), engine RPM present will display when the special test is started while the engine is running or during the test, if engine RPM is detected.Press CLEAR key to reset the fault and go to the Special Test screen (Fig 3.40).How To View The Engine Start Fuel Actuator Position Screen (Function 40)
Fig 3.46* Press Select Mode key* Press 4 key* Press 0 key* Press ENTER keyThe Engine Start Fuel Actuator Position screen (Fig 3.46) is displayed.Press ALT1 key to program the engine start fuel actuator position.How To View The Exhaust Oxygen Rate Screen (Function 41)
Fig 3.47* Press Select Mode key* Press 4 key* Press 1 key* Press ENTER keyThe Exhaust Oxygen Rate screen (Fig 3.47) is displayed.Press ALT1 key to program the exhaust oxygen rate.How To View The Desired Engine Start Up Timing Screen (Function 42)
Fig 3.48* Press Select Mode key* Press 4 key* Press 2 key* Press ENTER keyThe Desired Engine Start Up Timing screen (Fig 3.48) is displayed.Press ALT1 key to program the desired engine start up timing.How To View The Desired Engine Timing Screen (Function 51)
Fig 3.49* Press Select Mode key* Press 5 key* Press 0 key* Press ENTER keyThe Desired Engine Timing screen (Fig 3.49) is displayed.The Desired Engine Timing screen displays programmed engine timing.Press ALT1 key to program the desired engine timing.How To View The Calibrate Timing Screen (Function 51)
Fig 3.50* Press Select Mode key* Press 5 key* Press 1 key* Press ENTER keyThe Calibrate Timing screen (Fig 3.50) is displayed.Press ALT1 key to calibrate engine timing.
Fig 3.51The Calibrate Timing In Progress screen (Fig 3.51) will display when the calibration is in progress.
Fig 3.52The Calibrate Timing Passed screen (Fig 3.52) will display when the calibration is complete and passed successfully.Press ALT1 key to reset the test and go to the Calibrate Timing screen (Fig 3.49).How To View The Calibrate Oxygen Sensor Screen (Function 60)
Fig 3.53* Press Select Mode key*