TUBE 2H9628 - Caterpillar

Which Generate This Code:This diagnostic code is associated with the Right Joystick at the Forward-Rearward location for the Position Sensor. The position sensor provides a PWM input signal to the Machine ECM. The FMI 13 diagnostic code is activated when the ECM detects that the sensor needs to be calibrated.The possible causes of this diagnostic code are listed:
The ECM has been replaced or new software has been installed.
The calibration procedure has failed.Note: The sensor does not connect directly to the frame ground. The sensor connects to the return circuit of the ECM. The ECM internally connects the return wire to frame ground. In order to correct this diagnostic code, calibrate the sensor.Test Step 1. CALIBRATION
Perform the calibration procedure for the sensor. Refer to Testing and Adjusting, "Calibration" section of this manual for the correct calibration procedure. Verify that the calibration procedure for the ECM has been successfully completed. The calibration must complete without warnings in order to clear the FMI 13.
Observe the status of the CID 2475 - FMI 13.Expected Result:The calibration procedure was performed successfully. CID 2475 - FMI 13 has been clearedResults:
YES - The calibration procedure was performed successfully. Resume normal machine operation.STOP
NO - The calibration was not successful.Repair: Repeat the calibration procedure for the sensor. If the second calibration procedure is not successful, replace the Joystick assembly. After Joystick replacement, refer to Testing and Adjusting, "Calibration" section of this manual for the correct calibration procedure. If the problem is still present after replacement and calibration of the new joystick, the ECM may have failed.Prior to replacing an ECM, always contact your dealership's Technical Communicator for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the cause of the diagnostic code is not found, replace the ECM. Refer to Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP