AVSPARE.COM
parts catalog

TUBE A.-AIR 2H9966 - Caterpillar



2H9966 TUBE A.-AIR Caterpillar parts TUBE
Rating:
26
Alternative (cross code) number:
CA2H9966
2H-9966
2H9966
Caterpillar 2H9966 TUBE A.-AIR
Weight: 0.07 pounds 0 kg.

Buy TUBE A.-AIR 2H9966 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

"Some settings are missing or invalid, and will be reset to factory defaults"
On start-up or after restoring a display configuration, or display or machine settings file, some of the settings on the Display are missing or invalid. The settings will be set to the default values. Try the following:
Restore a display settings or machine settings file that is suitable for the machine setup.
Ask your supervisor to configure the AccuGrade System for use on your machine. Save the configuration of the Display."The design file could not be saved"
The Display could not save the level design file or could not save the sloping surface design file that is being created or edited.Check that the data card is correctly inserted into the data card slot. Ask your supervisor to check that the data card:
is not full
is not corrupt
has attributes that allow write access"The design you selected could not be loaded"
There is a problem with the design file, or the card has been removed from the Display.Check that the card is inserted correctly. Load the design again.The display configuration file could not be read
The Display is unable to restore the selected display configuration file. Remove and reinsert the data card. Check that the display configuration file is not corrupt. You can use the AccuGrade Office software to check the contents of a display configuration file."The GPS receiver configuration has not been updated"
The coordinate system may not be set correctly for the design.Try the following:
Check the cable connections to the GPS receivers.
Check the "Diagnostics" dialog and the "Diagnostics - GPS" dialog to see if the GPS receivers are responding.
Switch the machine power off and then switch the machine power on.
Ask your supervisor to check that the coordinate system in the design folder is correct."The GPS receiver firmware is old. Upgrade to V1.34 or greater for correct operation."
For AccuGrade version 10.8, your GPS receiver must be operating with the correct firmware. Contact your supervisor to complete the firmware upgrade from the AccuGrade Software CD."The GPS receiver needs a configuration file sent to it"
There is no known coordinate system in the GPS receiver.Try the following:
Load a design.
Load a file for the configuration of a display.Contact your supervisor in order to load the appropriate GPS receiver configuration file to the receiver.The office is transferring a file. Map recording has been paused and you cannot select a different design. Wait for the file transfer to finish or contact the office.
The office is sending new data to your Display through a wireless transfer. You can continue to work in the current design but map recording is paused.The office has finished the file transfer. You may select a different design.
The office has completed transferring the new data to your Display. You can continue map recording if it was paused at the start of the office file transfer."The reference surface list for this design could not be loaded"
The reference surface file (*.ofs) for your design that is selected could not be loaded. This means that no reference surfaces other than


Parts tube Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.