TUBE AS 2V5704 - Caterpillar

Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
ECM Identification Parameters
Engine Serial Number 0XX00000 or XXX00000 Blank Factory
ECM Serial Number Hardware Dependent Blank Read Only(1)
ECM Part Number Hardware Dependent Blank Read Only(1)
Software Group Part Number Software Dependent Read Only(1)
Software Group Release Date Software Dependent Read Only(1)
Software Group Description Software Dependent Read Only(1)
System Parameters
FLS Programmed at the Factory Factory
FTS Programmed at the Factory Factory
Test Spec Software Dependent Read Only(1)
Total Tattletale 0 to 65535 0 Read Only(1)
Engine Configuration Parameters
Engine Fan Control On
Off On Factory
Low System Battery Voltage Elevated Idle Enabled
Disabled Enabled None
Ether Solenoid Configuration Not Installed
Continuous Flow Solenoid Continuous Flow Solenoid Customer
Engine Fan Reversing Feature Enabled
Disabled Disabled None
Security System Immobilizer Installation Status Installed
Not Installed Not Installed Factory
Engine Retarder Enable Command (Option) Enabled
Disabled Disabled None
Engine Warm-up Elevated Idle Feature Enable Status Enabled
Disabled Disabled None
Machine Working Engine Low Idle Speed Configuration 650 - 1000 800 None
Machine Hibernating Engine Low Idle Speed Configuration 600 - 800 600 None
Engine Idle Shutdown Enable Status Enabled
Disabled Enabled None
Engine Idle Shutdown Delay Time 3 to 60 minutes 5 minutes None
(1) This parameter can be viewed only. No changes are allowed.Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
Engine Serial Number
ECM Part Number
ECM Serial Number
Software Group Part Number
Software Group Release Date
Software Group Description
FLS
FTS
Total Tattletale
Engine Fan Control
Low System Battery Voltage Elevated Idle
Ether Solenoid Configuration
Engine Fan Reversing Feature
Security System Immobilizer Installation Status
Engine Retarder Enable Command (Option)
Engine Warm-up Elevated Idle Feature Enable Status
Machine Working Engine Low Idle Speed Configuration
Machine Hibernating Engine Low Idle Speed Configuration
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Time
Table 3
Information From Engine Information Plate
Engine Serial Number
FLS
FTS
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Use of incorrect parameters could damage the engine. Use of the incorrect parameters may also void the Caterpillar warranty or the emission certification for the engine.