TUBE ASSEM. 2V6048 - Caterpillar

Illustration 7 g01476954
Press down key (8) until "Calibrations" is highlighted on the display screen.
Press OK key (9) .
Illustration 8 g01477512
Press down key (8) until "Reverse Currents" is highlighted on the display screen.
Press OK key (9) .
Press OK key (9) in order to begin the calibration.
Move parking brake switch (1) to the ON position.
Rotate speed dial (2) to the midrange position.
Illustration 9 g01477518
Move propel mode switch (10) to the PAVE position.
Move propel lever (3) to the NEUTRAL position.
Press OK key (9) .Note: If the display does not advance after pressing the OK key, observe the display and make sure that all required conditions are met. If all the conditions appear to be met but the display will still not advance, adjust speed dial (2). Adjust the speed dial by small increments to either side of the midrange position until the display will advance.
Illustration 10 g01477521
Move parking brake switch (1) to the OFF position.Note: The parking brake switch on the inactive instrument panel must also be in the OFF position.Note: The machine will move with a high rate of speed. Allow adequate space during the next step.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Move propel lever (3) to the REVERSE position.
Illustration 11 g01477554
Display should read "Calibrating speed sensors".Note: Observe the display. When the speed sensors have been calibrated, the display will prompt the operator to move the propel lever to the NEUTRAL position.
Illustration 12 g01477572
Move the propel lever (11) to the NEUTRAL position.
Illustration 13 g01477579
Move propel lever (3) to the REVERSE position.Note: At this point, the system is performing the coarse calibration of the initial current for the propel pumps.
Move propel lever (3) to the NEUTRAL position.
Move propel lever (3) to the FULL REVERSE position.
Illustration 14 g01477582
Display should read "Calibrating initial current for reverse pumps".Note: At this point, the system is performing the fine calibration of the initial current for the propel pumps.
Illustration 15 g01477583
Move the propel lever to the NEUTRAL position.
Illustration 16 g01477593
The display should now read "CALIBRATION COMPLETE". Push back key (11) to return to calibration screen.
Push home key (7) in order to exit the calibration screen.
Move parking brake switch (1) to the ON position.
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 17 g01477613
After the engine reaches low idle, move engine start switch (12) to the OFF position.