TUBE AS 2W5775 - Caterpillar

Tilt Back
Tilt Back - Move the joystick to the left in order to tilt the work tool upward.Float
Float - Float allows the work tool to follow the contour of the ground.The following conditions will activate the float function on the machine.Move the joystick to the lower position and press the trigger on the right-hand joystick. Float is activated. You may now release the trigger.Once the float function is engaged, the joystick can be returned to the neutral position without affecting the float function. Float will remain engaged until the trigger on the right-hand joystick is pressed again. The float function will disengage also when the bucket is raised or when the bucket is lowered.Note: If the float function is enabled, the AccuGrade option is disabled.Auxiliary Hydraulic Controls
If the work tool has a wiring harness, connect the work tool harness to the electrical plug on the loader arm. If your High Flow work tool does not have a wiring harness, a Jumper Plug should be installed on the electrical plug for the work tool control. Without this Jumper Plug, the machine will not provide High Flow to the work tool. Refer to your Parts Manual for the current part number for the Jumper Plug.Note: High flow mode requires an electrical connection that is located on the loader arm. Refer to Operation and Maintenance Manual, "Work Tool Coupler Operation" or Operation and Maintenance Manual, "Work Tool Operation" for additional details.Note: If the high flow work tool does not have a wiring harness, consult the Operation and Maintenance Manual for the work tool for the proper instructions for attaching the work tool.
Illustration 22 g02622087
Auxiliary Flow Connections
Auxiliary Hydraulic Control (A1) - This control provides hydraulic oil flow to the auxiliary connections on the loader arm. Engage the control in order to provide hydraulic oil flow to the connector (K).
Auxiliary Hydraulic Control (A2) - This control provides hydraulic oil flow to the auxiliary connections on the loader arm. Engage the control in order to provide hydraulic oil flow to the connector (J).
Illustration 23 g02931218
Typical electrical connection on the loading arm
(A) Left Hand Trigger Control “AUX 7”
(C) C- Control
(D) C+ Control
(E) C2 Control
(F) C1 Control
(J) Auxiliary Electrical Control “AUX 8”
Auxiliary Electrical Control 3 (C−) - This control provides electrical power in order to activate additional work tool functions using a three-position diverter valve that is located on some work tools. Press