TUBE AS 3085180 - Caterpillar

Keep engine speed low until the engine oil pressure light goes out. If it does not go out within 10 seconds, stop the engine and investigate the cause before starting again. Failure to do so, can cause engine damage.
1. Allow a cold engine to warm up at LOW IDLE for at least five minutes. 2. Look at the gauges and indicators frequently during operation.If any of the warning indicator lights stay on, have the necessary repairs made before operating the machine.Frequently look at the operator's panel during operation. If any of the warning indicator lights comes on, stop the machine if necessary and investigate.In case the engine does not start after several attempts, do not continue. Find the cause.Machine Operation
Be sure no one is working on or near the machine to prevent injury. Keep the machine under control at all times to prevent injury.Reduce engine speed when maneuvering in tight quarters or when breaking over a rise.Select the gear range necessary before starting downgrade. Do not change gears while going downhill.A good practice is to use the same gear range going downgrade that would be used to go up the grade.Do not allow the engine to over speed downhill. Use the service brake pedal to reduce engine over speed going downhill.1. Adjust the operator's seat.2. Fasten the seat belt. 3. Push down on the service brake pedal to keep the machine from moving. 4. Pull up the parking/secondary brake knob to release the parking/secondary brake. 5. Select the desired gear range. 6. Engage the clutch. 7. Move the direction and speed control lever in the desired direction. Drive the machine forward for best visibility and control.
For operator comfort and maximum service life of power train components, deceleration and/or braking is recommended before any directional shifts are made.