TUBE AS 3145676 - Caterpillar

Illustration 20 g00625333
Illustration 21 g00625335
Assemble valve group (X).
Install O-ring (30), spring (31), valve (32), and O-rings (33).
Assemble valve (28).
Illustration 22 g00625332Note: Lubricate the valve bores with a light coat of oil prior to installing the valves.
Install valves (29). Tighten valves (29) to a torque of 90 5 N m (65 4 lb ft). Install valves (28). Tighten valves (28) to a torque of 102 7 N m (76 5 lb ft).
Illustration 23 g00625306
Install O-ring seals (9) and (11). Check the condition of lip seal (10). Install lip seal (10).Note: Put a light coat of oil on the O-rings and the lip seal.
Install shim (12) into the pump housing. Apply grease to the shim in order to hold the shim in position.
Illustration 24 g00625288
Use a suitable wrench to rotate the shaft.
Install retainer (8) and four bolts (7).
Install an eyebolt into the end of the shaft. Install a dial indicator to the end of the shaft. Check the end play of the shaft by pulling on the eyebolt. The correct end play is 0.05 to .20 mm (0.002 to .007 inch). Install shims under retainer (8) in order to achieve the desired end play.Note: The spring in the barrel provides 2670 N (600 lb) of load. Put a prybar through the eyebolt in order to overcome the load on the spring.
Illustration 25 g00625318
Illustration 26 g00625331
Illustration 27 g00625317
Install bushing (27).
Install shaft (26). Install key (25) onto shaft (26).
Install O-ring (24) onto the pump housing. Install gears (22) and (23) onto shaft (26). Make sure that the reference marks on gears (22) and (23) are visible. Use Tooling (G) to install retaining ring (21).
Illustration 28 g00625315
Install O-ring seal (20) onto bolt (15). Install bolt (15), spring (19), and spacer (18).
Illustration 29 g00625311
Install pump (17) and three bolts (16).
Tighten bolt (15).
Illustration 30 g00672129
Install coupling (14) and three bolts (13).
Illustration 31 g00625286
Install seals (6) onto gear (5).
Illustration 32 g00625283
Illustration 33 g00625281
Install gear (5) onto the shaft.
Install belleville spring (2) and spacer (3) onto the shaft.Note: The concave surface of belleville spring (2) must be placed against the gear.
Use Tooling (A) to compress belleville spring (2). Use Tooling (F) to install retaining ring (4).End By:
Install the steering pump. Refer to Disassembly and Assembly, "Steering Pump - Install".