TUBE AS 3157501 - Caterpillar

Illustration 71 g01442792
Typical Example
Install retaining ring (26) onto input shaft (27).
Illustration 72 g00675820
Install pins (23).
Apply clean oil to clutch discs (24) and on clutch plates (25). Install clutch discs (24) and clutch plates (25) in alternating order. Start with a clutch disc (24).
Illustration 73 g00675819
Install springs (22).
Illustration 74 g00393001
Install bearing (21) into end plate (20).
Illustration 75 g01442747
Use Tooling (B) and a suitable lifting device in order to install end plate (20). The weight of end plate (20) is approximately 57 kg (125 lb). Note: Make sure that the slot in the bearing aligns with the dowel in the carrier assembly.
Illustration 76 g00392876
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install the washers and bolts (19) in end plate (20). The torque for the bolts is 410 50 N m (302 37 lb ft).
Install retaining ring (18) onto the carrier assembly.
Illustration 77 g00392874
Install pilot plate (17). Install the washers and bolts (16).
Illustration 78 g02547688
Use Tooling (B) and a suitable lifting device in order to install transmission case assembly (4) onto housing assembly (15). The weight of transmission case assembly (4) is approximately 211 kg (465 lb).
Install the washers and bolts (14) that secure transmission case assembly (4) to housing assembly (15).
Install the transmission hydraulic control valve. Refer to Disassembly and Assembly, "Transmission Control Valve - Install".
Illustration 79 g01442686
Install O-ring seals (13) on each sleeve (11).
Illustration 80 g01442674
Install sleeves (11) into transmission hydraulic control valve (12). Install the retainer and bolt (10).
Illustration 81 g02547536
Install O-ring seals (9) and (8) into manifold (6).
Illustration 82 g02547497
Position manifold (6) and install bolts (5) onto transmission case assembly (4).
Install tube assembly (7).
Illustration 83 g02547376
Check the condition of the gasket that is used with cover (3). If the gasket is damaged, use a new part for replacement. Install bolts (1) and bolts (2) in order to secure the gasket and cover (3) to transmission case assembly (4). End By:
Connect the input transfer gears and the output transfer gears to the transmission.