TUBE 3281884 - Caterpillar

OP2 is the option for viewing the setpoints of the generator set. The engine setpoints and the generator setpoints affect the operation and serviceability of the engine. The setpoints affect the accuracy of the information that is shown on the display. The setpoints that are viewed on the GSC should match the specified setpoints of the control panel. The programmable setpoints that are covered under OP2 are P01 through P24. See Systems Operation, "Setpoint Programming OP5" for a description of each of these setpoints. Procedure To View The Setpoints
Press the "SERVICE MODE" key in order to enter service mode. "OP 1" is showing on the lower display. See Systems Operation, "Service Mode"for more information.
Press "SCROLL UP" key. "OP 2" is showing.
Press "SELECT" key. "P01" is followed by the value of the setpoint that is showing.
Press "SCROLL UP" or "SCROLL DOWN" key. The next setpoint is showing with the corresponding value. Repeat this step until all the desired setpoints and corresponding values are viewed.
Press "EXIT" key. "OP 1" is showing on lower display.
Press "EXIT" key. The display returns to the normal mode.