TUBE AS 3533068 - Caterpillar

Pinch PointStay clear of this area!Serious personal injury may occur.
Position Tooling (A) to hold the front track roller frame in position in the rear track roller frame.
Attach a suitable lifting device and Tooling (E) to the track roller frame. The weight of the track roller frame is approximately 9979 kg (22000 lb). Use Tooling (E) to install the track roller frame on the equalizer bar.
Illustration 6 g01414538Note: Make sure that you install the thrust washer before you install plate (12)..
Position plate (12) on the end of the pivot shaft. Install bolts (11). Tighten bolts (11) to a torque of 1150 150 N m (850 110 lb ft).
Illustration 7 g00525912
Position Tooling (C) under the front track roller frame, as shown. Support the weight of the track roller frame with Tooling (C).
Remove Tooling (E) from the track roller frame.
Illustration 8 g01414865
Illustration 9 g02020569
Use Tooling (C) to move the track roller frame until pin (10) can be installed.
Install Tooling (G) in the end of pin (10) and install pin (10) in the track roller frame.
Install spacers (27). Install bolts (9), the washers, and the nuts.
Install guard (25). Install bolts (26) hand tight.
Tighten bolts (9) to a torque of 1825 175 N m (1340 130 lb ft).
Push guard (25) against the roller frame and tighten bolts (26).
Install the spacer and the retaining ring on the end of pin (10).
Use a flat bar to ensure that the front seal (inner ring) is in the neutral position.
Illustration 10 g01414960
Illustration 11 g02020520
To prevent damage to the pivot shaft seal, do not install the bolts that hold the pivot shaft seal retainer to the main frame case until the equalizer bar has been connected to the track roller frame.
Align the holes in retainer assembly (7) with the holes in the main frame case and install bolts (8).
If necessary, install washers (23) and spacer (24). Install washers (22) and bolts (21).
Remove Tooling (C) from the front track roller frame.
Illustration 12 g01414954
The O-ring seal must be in position on the plate (5). Put clean SAE 30W oil on the O-ring seal.
Install plate (5) in the track roller frame.
Install spiral lock ring (4) to hold the plate in position.
Install plug (6) in plate (5).
Illustration 13 g01414894
Install drain plug (3).
Fasten a suitable lifting device to trunnion (1). The weight of trunnion (1) is approximately 147 kg (325 lb). Position trunnion (1) on the track roller frame and install bolts (2).
Illustration 14 g01414487Note: Tooling (F) should be placed near the outer edge of the case, forward of the pin bore for the ripper toproperly support the weight of the machine. Improper placement of Tooling (F) could cause damage to the underside of the case.
Lower the front of the machine to the ground and remove Tooling (F).
Lower the rear of the machine to the ground and remove Tooling (F).
Illustration 15 g01425311
Remove Tooling (A) from the track roller frame.
Fill the reservoir for the pivot shaft with oil to the correct level. Refer to the Operation and Maintenance Manual, "Pivot Shaft Oil Level - Check".End By:
Connect the track. Refer to