TUBE AS 3534813 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-9200     Lever Puller Hoist     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01311983
Illustration 2 g01311873
Illustration 3 g01311877
Attach Tooling (A) and a suitable lifting device to engine (15). The weight of engine (15) is approximately 1588 kg (3500 lb). Position engine (15). Install bolts (14) and (16) .
Illustration 4 g01311933
Connect hose assemblies (12). Connect harness assembly (13) .
Illustration 5 g01311867
Illustration 6 g01311869
Connect hose assemblies (10) and (11).
Illustration 7 g01308314
Position harness assemblies. Install the bolt and clip (9).
Illustration 8 g01311451
Illustration 9 g01311452
Connect cable assembly (4). Connect harness assemblies (3) and (5). Connect hose assembly (6). Connect cable assembly (7). Install bolts (8) .
Illustration 10 g01308313
Illustration 11 g01311450
Connect hose assemblies (1) and (2) .End By:
Install the drive shaft. Refer to Disassembly and Assembly, "Driveshaft - Remove and Install".
Install the radiator guard and the radiator. Refer to Disassembly and Assembly, "Radiator Guard and Radiator - Install".
Install the rear and the middle bottom guard. Refer to Disassembly and Assembly, "Bottom Guard - Install".
Install the dash panel. Refer to Disassembly and Assembly, "Dash Panel - Remove and Install ".