TUBE AS 3534988 - Caterpillar

Apply gear oil through the fittings with a hand operated lubrication pump or a suitable grease gun. Use of pressure operated lubricating equipment damages the seals.
Before and after the equalizer bar end pin is filled with gear oil, seal (1) must be flush with the equalizer bar. If the seals are not flush, damage to the seals can result by overfilling.
Illustration 1 g00586840
Typical lubrication pump
The equalizer bar end pins are located between the front track roller frame and the main frame assembly.
Illustration 2 g01963428
Illustration 3 g01415023
Clean the areas that are around the end pin with a high pressure wash. Inspect the condition of the seal (1).
Check the area for oil leakage. Be sure that the seal is in a neutral position.
Remove plug (2).
Check the oil level. Oil level (4) should be at the top of the hex head on the fitting.
If the oil level is low, apply the gear oil through fitting (3) until the gear oil reaches oil level (4) at the top of the hex head on the fitting. Remove any excess oil. This will maintain a volume of air. The gear oil must be applied with a 7H-1680 Lubrication Hand Pump. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the correct oil. The gear oil has excellent load carrying capacity.
Be sure that seals (1) are not pushed out. Push back the seals if the seals are pushed out.
Install plug (2). Note: MPGM GREASE IS ALLOWED ONLY FOR A FAILED SEAL. THE SEAL SHOULD BE REPLACED AS SOON AS POSSIBLE. THE COMBINATION OF GEAR OIL AND MPGM IS NOT HARMFUL TO THE MACHINE.When you operate the machine in arctic conditions, lubricate the equalizer bar with EMGARD EP 75W90 gear lubricant. EMGARD EP 75W90 gear lubricant is a synthetic lubricant. This lubricant is available from Hudson Corporation.