TUBE 3C8493 - Caterpillar

3C8493 TUBE Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3C8493
3C-8493
3C8493

Weight: 3 pounds 1 kg.

Buy TUBE 3C8493 Caterpillar genuine, new aftermarket tractor parts with delivery

For full view, you need register

Information:

Remove bolts (2) and engine lifting bracket (1) from the flywheel housing.
Illustration 2 g01193112
Remove tube assemblies (3) .
Illustration 3 g01192982
Attach Tooling (A) and a suitable lifting device to flywheel housing (7). The weight of flywheel housing (7) is approximately 100 kg (220 lb).
Remove bolts (8) and bolts (9) .
Remove bolts (4) .
Remove cover (5) and cover (6) .
Illustration 4 g01192988
Remove bolt (10) .
Illustration 5 g01192991
Remove bolts (11) from the oil pan.
Remove the flywheel housing and the gasket from the cylinder block.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
B 230-6262 Sealant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install a new gasket on the cylinder block. Apply Tooling (B) to the oil pan gasket.
Illustration 6 g01192982
Illustration 7 g01192988
Illustration 8 g01096238
Attach Tooling (A) and a suitable lifting device to flywheel housing (7). The weight of flywheel housing (7) is approximately 100 kg (220 lb). Position flywheel housing (7) on the cylinder block.
Install bolts (4) .
Install bolts (8) and bolts (9) .
Install bolt (10) .
Tighten the bolts, by using the following procedure.
In a numerical sequence, tighten Bolt (1) through Bolt (17). Tighten the bolts to a torque of 40 10 N m (30 7 lb ft).
In a numerical sequence, again tighten Bolt (1) through Bolt (8). Tighten the bolts to a torque of 135 20 N m (100 15 lb ft).
In a numerical sequence, again tighten Bolt (9) through Bolt (17). Tighten the bolts to a torque of 55 10 N m (41 7 lb ft).
Install cover (5) and cover (6) .
Illustration 9 g01192991
Install bolts (11) for the oil pan.
Illustration 10 g01193112
Install tube assemblies (3) .
Illustration 11 g01192959
Install engine lifting bracket (1) and bolts (2) on the flywheel housing.End By:
Install the fuel filter and water separator base. Refer to Disassembly and Assembly, "Fuel Filter and Water Separator - Remove and Install".
Install the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Install".