TUBE 4256232 - Caterpillar

Warning Signs
There are several specific warning signs on this machine. Their exact location and a description of the hazard are reviewed in this section. Please become familiar with all warning signs.Make sure all warning signs can be read. Clean or replace the warning signs if the words cannot be read, or the illustrations are not clear. When cleaning the warning signs, use a cloth, water, and soap. Do not use solvent, gasoline, etc., to clean the warning signs. Solvents or gasoline, etc., could loosen the sign adhesive and allow the sign to fall off.Replace any warning sign if it is damaged, missing, or cannot be read. If a warning sign is attached to a part that is replaced, make sure a new sign is installed on the replaced part. See your dealer for new labels.
Do not remove guards, clean, oil or repair machine while in motion.
Illustration 2This warning is located on the front and back sides of the engine.
Stay clear if engine is running.
Illustration 3This warning is located on both sides of the rear of the machine, on either side of the elevator.
PINCH POINT AREA. Keep clear while machine is in operation.
Illustration 4This warning is located on each leg tower and on both sides of the rotor housing.
Do not fill over 95% liquid capacity. Use diesel fuel only.
NO SMOKING within 50 feet during fueling or washdown.
Illustration 5These warning signs are located on the fuel tank.
Stand clear if engine is running.
Illustration 6This warning is located in four places on the machine: two at the front and one on either side, towards the rear of the machine.
DO NOT exceed 15 mph (24 kph) with this unit in towing configuration. Exceeding the specified speed may cause tire failure or serious accident.
Illustration 7This warning is located on the front of the machine.
Clean fuel, lubricants and hydraulic oil from walkways.
Illustration 8This caution is located on the front of the machine.
Improper jumper cable connections can cause explosion resulting in personal injury.Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal. (If machine not equipped with starter negative terminal, connect to engine block.) Follow the procedure in the operation manual.
Illustration 9This warning is located on the bottom of the battery compartment cover.