TUBE 4384591 - Caterpillar

Illustration 1 g03626507
(1) Body up switch
(2) Magnet
(3) Plate
Illustration 2 g03626509
(A) 10 mm (0.394 inch)
(1) Body up switch
(2) Magnet
Adjust plate (3) so the gap between switch (1) and magnet (2) is 10 mm (0.394 inch).
Remove the body retaining pins and lower the dump body into the DOWN position.
In order to adjust the snub position of the dump body to approximately 200 to 300 mm (8 to 12 inch) between the front of the body pads and the frame rail, cycle the dump body and observe the SNUB position. If the dump body reaches the SNUB position too early, move magnet (2) upward. If the dump body reaches the SNUB position too late, move magnet (2) downward.
Repeat Step 4 until the desired SNUB position of the dump body is obtained.