TUBE AS 4533472 - Caterpillar

Illustration 14 g01196973
(50) 263-7745 Control Harness (59) 262-8065 Harness (60) 266-9378 Bracket (61) 130-5300 Clip (65) 8T-4137 Bolt (66) 8T-4121 Washer (67) Weld Boss on ROPS
Use a 8T-4137 Bolt (65) and a 8T-4121 Washer (66) to assemble the 130-5300 Clip (61) to the 266-9378 Bracket (60). Refer to illustration 14.
Use a 8T-4137 Bolt (65) and a 8T-4121 Washer (66) to assemble the 130-5300 Clip (61) and 266-9378 Bracket (60) to the weld boss (67). Refer to illustration 14.
Assemble the 263-7745 Control Harness (50) and 262-8065 Harness (59) connectors to the 266-9378 Bracket . Refer to Illustration 14.
Illustration 15 g01196976
(40) 253-2587 Plate (45) 167-8984 Battery (50) 263-7745 Control Harness Installed on Top of ROPS (59) 262-8065 Harness on the rearward side of the ROPS (69) 8T-4137 Bolt (70) 8T-4121 Washer (71) 033-8248 P Clip (75) Top rearward edge of ROPS
Remove the 8T-4137 Bolt (69) and the 8T-4121 Washer (70) from the 253-2587 Plate (40). Assemble the bolt (69) and washer (70) to the 033-8248 Clip (71). Assemble the bolt (69) back into the original location. Refer to illustration 15.
Connect the battery connectors of the 263-7745 Control Harness (50) to the two connectors of the 167-8984 Battery (45) .Note: If the GPS Receiver will not be installed, then use a cable strap to secure the GPS Receiver connector to the 263-7745 Control Harness (50). Cover the connector to protect the connector from the environment.
Illustration 16 g01196978
(40) 253-2587 Plate (65) 266-9378 Bracket (66) 8T-4136 Bolt (67) 8T-4121 Washer
Install the 266-9378 Bracket (65) to the 253-2587 Plate (40). Use one 8T-4136 Bolt (66) and one 8T-4121 Washer (67). Refer to illustration 16.
Illustration 17 g01196982
(40) 253-2587 Plate (45) 167-8984 Battery (50) 263-7745 Control Harness (80) 8T-4136 Bolt (81) 8T-4121 Washer (82) 130-5300 Clips
Use one 8T-4136 Bolt (80) and one 8T-4121 Washer (81) to attach the two 130-5300 Clips (82) to the 266-9378 Bracket (65). Refer to illustration 17.
Assembly the battery connectors of the 263-7745 Control Harness (50) and the 167-8984 Battery to the 130-5300 Clips (82). Refer to illustration 17.Completing the Installation
Ensure that all connectors are secure. Ensure that all fasteners are tight.