TUBE AS 4537445 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments, the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Maintenance Recommendations
Sea Water Strainer - Clean/Inspect
Zinc Rods - Inspect/Replace
Daily
Closed Crankcase Ventilation (CCV) Filter Service Indicator - Check
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Every 50 Service Hours or Weekly
Sea Water Strainer - Clean/Inspect
Zinc Rods - Inspect/Replace
Initial 250 Service Hours (or at first oil change)
Injector Bolt Torque - Inspect
Every 250 Service Hours
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Every 500 Service Hours
Coolant Sample (Level 1) - Obtain
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Every 5700 L (1500 US gal) of Fuel or 400 Service Hours or 1 Year
Aftercooler Condensate Drain Valve - Inspect/Clean
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
First 5700 L (1500 US gal) of Fuel or 200 Service Hours
Engine Valve Lash - Check
Every 17 000 L (4500 US gal) of Fuel or 500 Service Hours
Closed Crankcase Ventilation (CCV) Fumes Disposal Filter - Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Crankcase Breather - Clean
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Turbocharger - Inspect
Every 28 400 L (7500 US gal) of Fuel or 1000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Heat Exchanger - Inspect
Injector Bolt Torque - Inspect
Every 56 800 L (15 000 US gal) of Fuel or 2000 Service Hours
Alternator - Inspect
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Starting Motor - Inspect
Water Pump - Inspect
Every 200 000 L (53 000 US gal) of Fuel or 5000 Service Hours
Maintenance Recommendations
Overhaul (Major)