TUBE AS-FUEL 4564331 - Caterpillar

(26)Engine Crankcase - Change Oil and Filter Element - Wash Breather
1. Oil should be warm, engine stopped and machine level. Remove crankcase filler plug and drain plug.2. Remove oil filter drain plug.3. Loosen filter housing retaining bolt. Remove housing and element.4. Clean filter base and install new seal.5. Install housing with new element. Clean and install drain plug.6. Loosen breather outlet clamp and mounting bolt. Remove breather.7. Wash breather in kerosene and blow dry. Install breather.8. Clean and install crankcase drain plug. Fill crankcase (Refill capacity on Page 31).9. Run engine for 2 minutes. Check oil level and add if necessary.(27)Hydraulic Control System - Change Filter Element
1. Lower all equipment and stop engine. Loosen tank bleed plug to relieve pressure.2. Remove filter cover and element. Inspect cover and use new seals if necessary.3. Install new element. Install cover and tighten to 43 4 lb. ft. (6 0, 6 mkg).4. Open bleed valve and start engine. Fill tank (refill capacity on Page 31).5. Close bleed valve when oil flows without bubbles.6. Operate equipment for a short time.7. Check oil level and add oil if necessary.(28)Transmission
Remove breather and wash in kerosene. Oil element lightly and install breather.(29)Flywheel Clutch
Remove breather and wash in kerosene. Oil element lightly and install breather.(30)Fuel Tank
1. Drain water and sediment from tank through drain valve. Remove filler cap and disassemble. Wash in kerosene. Assemble cap, and oil filter lightly. Install cap.