TUBE 4646005 - Caterpillar

Illustration 1 g00725764
This illustration shows the location of the new 166-4374 Ring Assembly (1) and the new 166-4376 Water Pump Seal (2) in a typical new water pump group.Adaptable To: The table identifies the new water pump groups and the corresponding former water pump groups for these engines. The new water pump groups are direct replacements for the former water pump groups.
Table 1
Corresponding New and Former Water Pump Group    
New Water Pump Group Pt. No.     Former Water Pump Group Pt. No.    
166-4377     122-0501    
166-4378     122-0500    
166-4379     122-0502    
166-4380     122-0503    
166-4381     122-0505    
166-4382     137-8242 or 122-0504    The new 166-4376 Water Pump Seal is a direct replacement for the 124-5245 Face Seal Group in the former water pump groups. The new 166-4374 Ring Assembly is adaptable to the former water pump groups if a hole (X) is drilled through the water pump housing. Illustration 2 identifies the location and the dimensions for hole (X). This new hole (X) will accept the pin (A) from the new ring assembly (1). See Illustration 3. This will keep the opening in the new ring assembly positioned toward the bottom of the installed water pump. This will allow any fluid that leaks past the water pump seals to flow to the water pump weep port.
Illustration 2 g00725766
This illustration provides the dimensions for adding a new hole (X) to the typical water pump housing. The hole (X) is 2.50 0.05 mm (0.098 0.002 inch) in diameter. The hole (X) is located at a radius (R) of 17.50 0.25 mm (0.689 0.010 inch). Drill hole (X) through the water pump housing.
Illustration 3 g00725767
This illustration shows the location of Pin (A) in a 166-4374 Ring Assembly .