TUBE ASSEM. 4V7314 - Caterpillar

Use the navigation keys select the days that PCT #1 timer will activate. Press the "OK" key when done. Note: To program Saturday, continue to scroll down past Friday.
Illustration 6 g02306093
Use the navigation keys select the "START TIME". Press the "OK" key.
Illustration 7 g02306113
Use the navigation keys to move the cursor right and left to select the desired "START TIME" (hours and minutes). After the cursor is placed on the desired minute or hour, use the up or down navigation keys change the minutes or hours that are displayed. Press the "OK" key when done.
Illustration 8 g02306133
Use the navigation keys to select the "RUN FOR" time. Press the "OK" key.
Illustration 9 g02306173
Use the arrow keys to set the "RUN FOR" time. After the cursor is placed on the desired minute or hour, use the up or down navigation keys change the minutes or hours that are displayed. Press the "OK" key when done.
Illustration 10 g02306193
Use the navigation keys to select the "OUTPUT STATE" for "Output #1" for this example. Press the "OK" key.
Illustration 11 g02306213
Select the desired "OUTPUT STATE". Press the "OK" key when done.
Illustration 12 g02306253
Use the same steps to select the "OUTPUT STATE" for Output #2 and Output #3 that were used to program Output #1.
Press the "ESCAPE" key to return to the programmable cycle timer main screen. Use the "LEFT" and "RIGHT" navigation keys to select other timers. Repeat the steps above to program other timers. Configure Programmable Cycle Timer Using Cat ET
The EMCP 4 programmable cycle timers can be configured using Cat ET. Perform the following steps to program programmable cycle timers.
Connect the EMCP 4 to Cat ET.
Select "Programmable Cycle Timer " on the left side of the dialog.
Illustration 13 g02307573
Double click the "Programmable Cycle Timer #N Activation Day" from the drop-down menu to change the day. Click the "OK" button to program.
Illustration 14 g02307633
Double click the "Start Time" set point to change the value. Click the "OK" button to program.
Illustration 15 g02307637
Double click the "Programmable Cycle Timer #N Active Time" set point to change the time that the output from the timer will be active. Click the "OK" button to accept the change.
Illustration 16 g02307675
Double click the "Programmable Cycle Timer #N Output #1 Active Configuration" set point to change the value. Select the desired choice from the drop-down menu. Click the "OK" button to accept the change.
Illustration 17 g02307677
Double click the "Programmable Cycle Timer #N Output #1 Active Configuration" set point to change the value. Select the desired choice from the drop-down menu. Click the "OK" button to accept the change.
Illustration 18 g02307678
Repeat the above steps to program additional timers.