TUBE AS 5072330 - Caterpillar

Steps 2 through 10 are for the installation of the pin assemblies.
Illustration 13 g01455939
Apply Tooling (H) to pin assembly (15).
Attach a suitable lifting device to pin assembly (15). The weight of pin assembly (15) is approximately 408 kg (900 lb). Install pin assembly (15) into the machine.Note: Install pin assembly (15) with the small outside diameter to the left side of the machine.
Steps 4.a through 4.f are for the assembly of Tooling (G).
Illustration 14 g01456010
(G1) Adapter Assembly (not shown)
(G2) Bushing
(G3) Nut
(G4) Sleeve Assembly
(G5) Cylinder Assembly
(G6) Hard Washer
(G7) Puller Stud
Install Puller Stud (G7) into pin assembly (15) (not shown) on the left side of the machine.Note: Be sure that the threads of Puller Stud (G7) are fully engaged into pin assembly (15) to a depth of approximately 80 mm (3 inch).
Install Adapter Assembly (G1) (not shown) onto Puller Stud (G7).
Use a suitable lifting device to install Sleeve Assembly (G4) onto Puller Stud (G7). The weight of Sleeve Assembly (G4) is approximately 57 kg (125 lb).
Use a suitable lifting device to install Cylinder Assembly (G5) onto Puller Stud (G7). The weight of Cylinder Assembly (G5) is approximately 57 kg (125 lb).
Install Bushing (G2) onto Puller Stud (G7).
Install Hard Washers (G6) and Nuts (G3) onto Puller Stud (G7).
Illustration 15 g01456226
Use Tooling (G) to seat pin assembly (15) (not shown) to the proper depth.Note: Pin assembly (15) (not shown) is properly seated when pin assembly (15) and adapter assembly (T) (not shown) contact sleeve assembly (C6).
Repeat Steps 2 through 5 for the remaining pin assembly.
Illustration 16 g01455519
Illustration 17 g01455524
Attach Tooling (B) and a suitable lifting device to front fender (10). The weight of front fender (10) is approximately 193 kg (425 lb). Use Tooling (B) and the suitable lifting device to position front fender (10) to the machine.
Install the washers and bolts (14). Install the washers and bolts (11).
Connect harness assembly (13) and connect clips (12).
Repeat Steps 7 through 9 for the opposite side of the machine.
Illustration 18 g01455484
Attach a suitable lifting device to lift cylinder (2). The weight of lift cylinder (2) is approximately 953 kg (2100 lb). Use the suitable lifting device to position lift cylinder (2) to the machine.
Position plate (9) and retainer plate (8). Apply Tooling (J) to bolts (7). Install the washers and bolts (7).Note: Plate (9) is only on the right side of the machine.
Connect hose assemblies (6).
Illustration 19 g01455450
Position plate (5) and plate (4). Apply Tooling (J) to bolts (3). Install the washers and bolts (3).Note: Plate (5) is only on the right side of the machine.
Repeat Steps 11 through 14 for the remaining lift cylinder.Air Evacuation Procedure
Air must be evacuated from hydraulic cylinders prior to use to prevent dieseling. Do not operate the implement functions until instructed to do so in this procedure.
Start engine. Do not increase engine speed above low idle.
While maintaining system pressure as low as possible, fully extend and fully retract the lift cylinders for ten cycles.
Lower the implement to the ground and shut off the engine.
Fill the hydraulic tank with fluid until the "FULL" level is reached