TUBE AS 5133065 - Caterpillar

5133065 TUBE AS Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5133065
513-3065
5133065

Weight: 12 pounds 5 kg.

Buy TUBE AS 5133065 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Polaris NOS Fitting 37 DEG 9/16-18 1/8" JIS - 5133065

$16.08

12 Apr 2022
0.0[0.00] Pounds
US: Sun Coast Cycle

Polaris NOS Fitting 37 DEG 9/16-18 1/8" JIS - 5133065
Polaris Genuine Polaris Part Number 5133065 - FITTING-37 DEG,9/16-18 1/8"JIS for Polaris ATV / Motorcycle / Snowmobile/ or Watercraft || Buy your parts from the largest Polaris OEM Parts Dealer in the Country || All Genuine Polaris Repair Parts have a 30 Day Manufacturers Warranty || Please do not order by description - Make sure you have the correct Part Number || We charge a 20% restock fee on Returns

Number on catalog scheme: 3

Caterpillar 5133065 Parts scheme TUBE AS

For full view, you need register

Information:

The digital voltage regulator (DVR) is a microprocessor-based voltage regulator. The parameters are preset at the factory or the parameters can be modified to meet the specific requirements on the site. Certain system parameters can also be monitored on the display (5) of the DVR. Keypad (9) is used to change the information that is shown on the display (5). J1 connector (10) is used to join the DVR to a personal computer. Screw terminals (11) are used to join the DVR to the generator and various customer options.Adjustment Procedure for the Voltage Regulators
VR3 Regulator
Note: The VR3 regulator is protected by a fuse or fuses. The VR3 regulator also has a solid-state overcurrent protection. If a fuse becomes open, contact a Caterpillar dealer.
Remove the access panel of the generator.
Loosen the locknut on the voltage droop potentiometer (1). Remove the protective screw from the voltage level potentiometer (2). Remove the protective screw from the voltage gain potentiometer (3).
Turn the voltage droop potentiometer (1) counterclockwise to zero droop. Tighten the locknut. The Voltage droop potentiometer (1) is located next to the regulator.
Remove the protective screw from the voltage level potentiometer (2). Remove the protective screw from the voltage gain potentiometer (3).
Turn the voltage gain potentiometer (3) counterclockwise to zero. Then, turn voltage gain potentiometer (3) to about 1/4 of full range of clockwise travel.
Perform required maintenance on the engine before you start the engine.
Start the engine. Allow the engine to warm up. Refer to the Safety Section, "Engine Starting".
Increase engine speed to full governed rated speed (high idle).
Observe the voltmeter reading. If the desired voltage is