TUBE AS 5338838 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     9U-5339     Bearing Puller Adapter (2)     1    
9U-5338 Bearing Puller Adapter (2)     1    
4C-9634 Puller Stud     1    
9U-6832 Nut     1    
6V-3175 Double Acting Cylinder     1    
3S-6224 Electric Hydraulic Pump (115 Volt) (1)     1    
9U-5266 Receiving Sleeve     1    
( 2 ) Used for removing the bearing that is located on the boom side of the stick
( 2 ) Used for removing the bearing that is located on the bucket side of the stick
( 1 ) 8S-8033 Electric Hydraulic Pump (230 Volt) is available.Start By:
Remove the stick. Refer to Disassembly and Assembly, "Stick - Remove".Note: For the removal of the sleeve bearings from the stick at the pin joint for the bucket control linkage, refer to Disassembly and Assembly, "Bucket Linkage Bearings and Seals - Remove".
Illustration 1 g00592359
Remove lip type seal (1) from the bore for the boom to stick pin.
Illustration 2 g00592391
Use Tooling (A) to remove the sleeve bearing.
Repeat Steps 1 and 2 in order to remove the lip type seal and the sleeve bearing from the opposite side of the stick.
Illustration 3 g00604131
Remove lip type seal (2) from the bore for the stick to bucket pin.
Illustration 4 g00687381
Use Tooling (B) to remove the sleeve bearing.
Repeat Steps 4 and 5 in order to remove the lip type seal and the sleeve bearing from the opposite side of the stick.