TUBE AS 6Y3288 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     129-1948     Water and Temperature Resistant Grease     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01264226
Lubricate the O-ring seal and the bore of the water pump with Tooling (A). Install elbow (15) and bolts (14) .
Illustration 2 g01264195
Illustration 3 g01264216
Position the water pump and elbow assembly (9). Install bolts (13) .
Install belt tensioner (12) and bolt (11) .
Tighten clamp (8). Install tube assemblies (7) and (10) .
Illustration 4 g01264188
Install flange (6) and bolts (4). Install hose (5) .
Illustration 5 g01264171
Install elbow (2). Tighten clamp (3). Connect hoses (1) .
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".