TUBE AS 6Y8912 - Caterpillar

"Low Cruise Control Speed Set Limit"
The "Low Cruise Control Speed Set Limit" sets the lowest vehicle speed that will allow the cruise control to be set. Programming this parameter to the maximum value disables cruise control.
Table 1
Minimum     Maximum     Default    
24 km/h (15 mph)    
204 km/h (127 mph)    
204 km/h (127 mph)    "High Cruise Control Speed Set Limit"
The "High Cruise Control Speed Set Limit" sets the highest vehicle speed that will allow the cruise control to be set. If a driver attempts to set a vehicle speed higher than this limit, the "High Cruise Control Speed Set Limit" will be the cruise set speed. If the "High Cruise Control Speed Set Limit" is programmed to a value that is greater than the vehicle speed limit, the cruise control switches can be used to exceed the programmed vehicle speed limit.
Table 2
Minimum     Maximum     Default    
48 km/h (30 mph)    
204 km/h (127 mph)    
204 km/h (127 mph)    "Cruise/Idle/PTO Switch Configuration"
"Cruise/Idle/PTO Switch Configuration" defines the function of the Set/Resume switch for "Accel" mode and "Decel" mode. This parameter affects cruise control mode, idle mode and PTO mode.
Table 3
Alternative     Default    
Set/Decel-Res/Accel     Set/Accel-Res/Decel    "Soft Cruise Control"
"Soft Cruise Control" provides a 8 km/h (5 mph) operating range around the cruise control set speed in order to provide a smoother cruise control. "Soft Cruise Control" controls the cruise speed within the following range:
4 km/h (2.5 mph) below the set vehicle speed at full load
4 km/h (2.5 mph) above the set vehicle speed at no load
Illustration 1 g00670797
Table 4
Alternative     Default    
No     Yes    "Adaptive Cruise Control Enable"
Adaptive cruise control reduces the need to manually cancel cruise control when you approach a slower vehicle. The system responds by decreasing the cruise control set speed until a following distance is obtained. If the slower vehicle speeds up, the cruise control set speed will be adjusted in order to maintain the following distance. Adaptive cruise control will restore the original set speed when there are no vehicles within the range of control. Adaptive cruise control will not increase the cruise control set speed above the original setting. If the vehicle is approaching the target too rapidly, the ECM will turn off the cruise control.
Table 5
Alternative     Default    
Enabled     Disabled