TUBE AS-FILLER 7C7765 - Caterpillar

Warning Signs And Labels
There may be several specific safety signs on your engine. Please take the time to familiarize yourself with the safety signs.Make sure that you can read all safety signs. Clean or replace these if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvents, gasoline, etc., to clean safety signs. The use of solvents, gasoline, etc., could loosen the sign's adhesive and cause the sign to fall off.You must replace a label if it is damaged, missing or cannot be read. If a label is on a part that is replaced, make sure a new label is installed on the replaced part. See your Caterpillar dealer for new labels.General Hazard Information
Attach a "DO NOT OPERATE" or similar warning tag to start switch or controls before servicing or repairing the truck engine. These tags, Form SEHS7332, are available from your Caterpillar dealer.Do not allow unauthorized personnel in the truck when it is being serviced.When operating the engine in a closed area, vent the exhaust to the outside.If the engine is not running, do not release the secondary or parking brake systems unless the truck is blocked or restrained.Wear a hard hat, protective glasses and other protective equipment as required by job conditions.Do not wear loose clothing or jewelry that can catch on controls or other parts of the engine.Make certain all protective guards and covers are secured in place.Use all cleaning solutions with care.Never put maintenance fluids into glass containers since glass containers can break.Report all needed repairs.* Stop the engine.* Ensure the protective locks or controls are in the applied position.* Apply the secondary (emergency) and parking brakes.* Block or restrain the vehicle before servicing.* Disconnect the batteries before servicing the electrical system.* Do not attempt repairs you do not understand.* Use proper tools and replace or repair broken or damaged equipment.* When starting an engine after repairs have been made to the fuel system, make provisions for shutting off the engine's intake air supply, (to stop the engine), in case there is an overspeed on start-up.* Start the engine only from the operator's station (cab). Never short across the starter terminals or the batteries as this could bypass the engine neutral-start system as well as damage the electrical system.Pressure Air And Water
Pressure air can cause personal injury. When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 30 psi (205 kPa) for cleaning purposes.Wear eye protection at all times when cleaning the cooling system. Pressurized water could cause debris and/or hot water to be blown and result in personal injury.Fluid Penetration
Always use a board or cardboard when checking for a leak. Escaping fluid under pressure, even a pin-hole size leak, can penetrate body tissue, causing serious injury, and possible death.If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury