TUBE AS-WATER VENT 7E6787 - Caterpillar

7E6787 TUBE AS-WATER VENT Caterpillar parts 235C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA7E6787
7E-6787
7E6787

Weight: 0.50 pounds 0 kg.

Buy TUBE AS-WATER VENT 7E6787 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 7E6787:

EXCAVATOR 235C Caterpillar

Number on catalog scheme: 36

Caterpillar 7E6787 Parts scheme TUBE AS-WATER VENT

For full view, you need register

Information:

Illustration 1 g01054206
Power distribution box
(1) 35 amp circuit breaker
Switch 35 amp circuit breaker (1) to the OFF position.
Illustration 2 g01064840
Rear view
(2) Connector for the harness to the thermocouples
(3) Connector for the harness to the ITSM
Disconnect connectors (2) and (3) from the ITSM.
Illustration 3 g01064841
Mounting hardware for the ITSM
(4) Nut
(5) Ground strap
(6) Washer
(7) Mounting flange on the ITSM
Remove four nuts (4) and washers (6) from mounting flanges (7) of the ITSM. Ground strap (5) must also be lifted from one of the studs.
Remove the ITSM from the engine.
Install the replacement ITSM. Orient the 54-pin connector toward the bottom of the engine.
Use the mounting hardware to install the new ITSM. Be sure to install ground strap (5) between one of the washers on the mounting flange and the nut. Note: One of the washers is a lock washer. Be sure to install the lock washer between ground strap (5) and mounting flange (7). The lock washer improves the electrical conductivity between the ground strap and the mounting flange.Check the mounting hardware and the ITSM for correct installation. A properly installed ITSM will move slightly on the rubber grommets. If the ITSM cannot move slightly on the grommets, check that the mounting hardware is installed correctly.
Connect connectors (2) and (3) to the ITSM.
Program the configuration parameters and the monitoring system parameters into the replacement ITSM.
Switch 35 amp circuit breaker (1) to the ON position.
Set the engine control to the STOP mode.
Select "File/Select ECM" from the drop-down menu of Cat ET.
Select the "Replacement ITSM" and click "OK".
Select "Service/Copy Configuration/ECM Replacement" from the drop-down menu. Click "OK" on the window.
Select "Program ECM" from the lower left corner of the screen. Select the replacement ITSM and click "OK".
After the loading is complete, a window with the message "Programming Complete" will appear. Select "OK". Note: When you program a new ITSM, factory passwords are not required. Also, the ITSM does not require calibration.