TUBE (DRAIN) 7H1027 - Caterpillar

Illustration 6 g01270307
Use the arrow keys to highlight the "3D, 1 Point Center" method.Refer to Illustration 6.
Illustration 7 g01270318
Press the "OK" key to confirm selection.Refer to Illustration 7.Method: "1 Point Focus"
The "1 Point Focus" method sets one vertical guidance point 0.2 m (0.6 ft) in from the blade tip that has focus. Use this method when you are working on a narrow section of the design where the cross slope does not change (for example, the shoulder of a road). Guidance changes with respect to the blade tip focus.
Illustration 8 g01270319
Use the arrow keys to highlight the "3D, 1 Point Focus" method.Refer to Illustration 8.
Illustration 9 g01270320
Press the "OK" key to confirm selection.Refer to Illustration 9.Method: "2 Points Tips"
The "2 Points Tips" method sets two vertical guidance points 0.2 m (0.6 ft) in from each blade tip. Use this method when you are working on an irregular design surface, where the cross slope changes across the width of the blade (for example, a golf course). Guidance does not change with respect to the blade tip focus.
Illustration 10 g01270332
Use the arrow keys to highlight the "3D, 2 Point Tips" method.Refer to Illustration 10.
Illustration 11 g01270334
Press the "OK" key to confirm selection.Refer to Illustration 11.Method: "1 Point Custom"
The "1Point Custom" method lets you set one vertical guidance point at a customized distance from the blade tip with focus. Guidance changes with respect to blade focus.In order to configure the "1 Point Custom" method, complete the following steps:
Illustration 12 g01270341
Use the arrow keys to highlight the "3D, 1 Point Custom" method.Refer to Illustration 12.
Press the "OK" key to confirm selection.
Illustration 13 g01270342
Press the "NEXT" key in order to highlight a field.Refer to Illustration 13.
Press the arrow keys in order to enter a value into the field."A" is the horizontal distance from the blade tip with focus to the guidance point. The vertical guidance point will change sides of the blade when the focus point changes. "A" must be a value between zero and the blade width.Method: "2 Points Custom"
Use the "2 Points Custom" method when a design surface requires extra control over the positioning of the vertical guidance points along the blade. The "2 Points Custom" method allows you to set two vertical guidance points at specified distances along the blade edge. Guidance changes with respect to blade focus. In order to configure the "2 Points Custom" method, complete the following steps:
Illustration 14 g01270343
Use the arrow keys to highlight the "3D, 2 Points Custom" method.Refer to Illustration 14.
Press the "OK" key to confirm selection.
Illustration 15 g01270346
Press the "NEXT" key in order to highlight a field.Refer to Illustration 15.
Press the arrow keys in order to enter a value into the field."A" is the horizontal distance from the blade tip with focus to the guidance point. The vertical guidance point will change sides of the blade when the focus point changes. "A" must be a value between zero and the blade width.
Press the "NEXT" key in order to highlight the "C" field."C" is the horizontal distance from the blade tip without focus to