TUBE ASSEM. (29.37" long) 7K2990 - Caterpillar

5. Check the shaft end play with dial indicator. If necessary, add or subtract shims; or turn nut to get the correct end play.Clutch Adjustment (Later)
1. Disconnect linkage (if so equipped) from the clutch lever.2. Use a torque wrench and apply torque to the splined clutch lever shaft until the clutch engages. Make reference to the chart to find the correct amount of torque needed for the clutch assembly. 3. If the torque needed to engage the clutch is not correct, make an adjustment as follows:4. Remove the inspection plate from the clutch housing.5. Turn the clutch until lock pin (1 or 2) can be seen.6. Release push type lock pin (1) or pull type lock pin (2). Turn the adjustment ring and check the torque needed to engage the clutch again. Turn the adjustment ring clockwise, as seen from the rear of the clutch, to increase the torque needed. Turn it counterclockwise to decrease the torque needed.
Clutch Adjustment
(1) Lock pin (push type) (2) Lock pin (pull type)Assembly Adjustments
End Play For Shaft Bearings
5N7329 & 5N7330 Clutch Groups
1. Install the output shaft, bearings and spacers in the clutch housing.2. Install the nut and lock on the shaft and tighten the nut to a torque of 750 70 N m (550 50 lb.ft.).3. Check the shaft end play with a dial indicator. Shaft end play is 0.08 to 0.25 mm (.003 to .010 in.).4. If the shaft end play is not within the range given, check the bearing and spacers for wear or damage and make a replacement as needed.3N8614 Clutch Groups
1. With dry bearings installed on the shaft install the shaft in the housing.2. Install the retainer. Tighten the retainer until 7 N m (60 lb.in.) is needed to keep the shaft in rotation.3. Measure the space between the retainer and the carrier. Add 0.33 mm (.013 in.) to this measurement. Install this amount of shims between the retainer and the carrier.4. Check the shaft end play with a dial indicator. If necessary, add or subtract shims. Correct shaft end play is 0.15 to 0.25 mm (.006 to .010 in.).3N8615 Clutch Groups
1. With dry bearings installed on the shaft, install the shaft in the housing.2. Install the retainer. Tighten the retainer until 7 N m (60 lb.in.) is needed to keep the shaft in rotation.3. Now, loosen the retainer 5 to 6 notches and install the bolt and lock to hold the retainer.4. Hit the output end of the clutch shaft. This will cause the front bearing cup to move against the retainer.5. Check the shaft end play with a dial indicator. Shaft end play is 0.25 to 0.30 mm (.010 to .012 in.).6. If necessary, remove the bolt and lock and turn the retainer to get the correct end play.Hub Nut Installation (Both Clutch Types)
1. Tighten the hub nut to a torque of 40 N m (30 lb.ft.).2. Tighten the nut more according to the chart. Flywheel And Flywheel Housing Alignment
At the time of installation of