TUBE ASSEM. 7K8562 - Caterpillar

Specifications
Illustration 1 g03357039
Table 1
Specification for 125-9358 Drive Shaft Gp    
Item     Qty     Part     Specification Description    
1     -     -     Tighten the bolts to
71 10 N m (52 7 lb ft).    
2     20     138-3816 Bolt     Torque to
170 13 N m (125 10 lb ft).    
3     8     -     Tighten the bolts to
58.5 6.5 N m (43.1 4.8 lb ft).    
4     1     390-4797 Slip Joint     The spline should be lubricated when the machine is fully articulated.    
Illustration 2 g03357040
Section A-A
Table 2
Item     Qty     Part     Specification Description    
5     1     8T-4176 Bolt     Before assembly, lubricate all surfaces entire length to Loctite C5A copper anti-seize to the assemble bearing    
Torque to
120 20 N m (89 15 lb ft).
6     4     7X-2554 Bolt     Torque to
240 40 N m (177 30 lb ft).    Removal Procedure
Start By:
Remove the carrier bearing.
Park the machine on a flat, level surface. Lower the bucket to the ground. Chock the wheels in order to keep the machine from rolling when the drive shaft is removed.
Illustration 3 g00446923
Support front drive shaft (2). Remove four bolts (3) and two straps (4) from yoke (1) .
Use two persons in order to remove front drive shaft (2). The weight of the front drive shaft is 20 kg (44 lb).Installation Procedure
Install front drive shaft (2) in the reverse order of removal.
Tighten bolts (3) to a torque of 150 15 N m (111 110 lb ft)