TUBE ASSEM. 7K8801 - Caterpillar

Note: Ensure that the Safety Information, warnings, and instructions are read and understood before operation or maintenance procedures are performed.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.Note: Some maintenance items are for optional equipment.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Oil Level Gauge - Calibrate
Fuel System - Prime
Severe Service Application - Check
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Every 250 Service Hours
Fuel Tank Breather - Replace
Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or 1 Month
Fuel System Secondary Filter - Replace
Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or Yearly
Engine Air Cleaner Element (Single Element) - Replace
Magnetic Pickups - Clean/Inspect
Every 19 000 L (5000 US gal) of Fuel or 500 Service Hours or 3 Months
Fuel System Primary Filter - Clean/Replace
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Engine Protective Devices - Check
Every 228 000 L (60 000 US gal) of Fuel or 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Overhaul
Overhaul Considerations
First 9500 L (2500 US gal) of Fuel or 250 Service Hours
Engine Valve Lash - Inspect/Adjust
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Turbocharger - Inspect
Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or Yearly
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 190 000 L (50 000 US gal) of Fuel or 5000 Service Hours
Air Compressor - Inspect
Alternator - Inspect
Cooling System Coolant (DEAC) - Change
Starting Motor - Inspect
Water Pump - Inspect