7K8892 TUBE ASSEM. Caterpillar parts
966C, 966R
Rating:
Alternative (cross code) number:
CA7K8892
7K-8892
7K8892
CA7K8892
7K-8892
7K8892
Weight: 11 pounds 4 kg.
WHEEL LOADER,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
CTP 7K8892 Tube Fittings for Models 966C/966R
CTP For Models 966C/966R || Highly Efficient || Easy in-and-out fit
CTP For Models 966C/966R || Highly Efficient || Easy in-and-out fit
CTP 7K8892 Tube Fittings for Models 966C/966R
CTP For Models 966C/966R || Highly Efficient || Easy in-and-out fit
CTP For Models 966C/966R || Highly Efficient || Easy in-and-out fit
Information:
The condition of charge in the battery at each regular inspection will indicate whether the charging system operates correctly. An adjustment is necessary when the battery is constantly in a low condition of charge or a large amount of water is needed. A large amount of water would be more than one ounce of water per cell per week or per every 100 service hours.When it is possible, test the charging unit and the voltage regulator on the engine. Use wiring and components that are a permanent part of the system. This testing will give an indication of needed repair. After repairs are made, perform a test in order to prove that the units have been repaired to the original condition of operation.To check for correct output of the alternator, see the Specifications module.For complete service information, refer to Service Manual Module, SENR7503, "Delco-Remy Bulletin 1G-255". This module is part of Service Manual, REG00636.Before the start of on-engine testing, the charging system and the battery must be checked according to the following steps.
The battery must be at least 75 percent (1.225 Sp Gr) of the full charge. The battery must be held tightly in place. The battery holder must not put too much stress on the battery.
Cables between the battery, the starter, and the engine ground must be the correct size. Wires and cables must be free of corrosion. Wires and cables must have cable support clamps in order to prevent stress on battery connections (terminals).
Leads, junctions, switches, and panel instruments that have direct relation to the charging circuit provide correct circuit control.
Inspect the drive components for the charging unit in order to be sure that the components are free of grease and oil. Be sure that the drive components have the ability to operate the charging unit.
The battery must be at least 75 percent (1.225 Sp Gr) of the full charge. The battery must be held tightly in place. The battery holder must not put too much stress on the battery.
Cables between the battery, the starter, and the engine ground must be the correct size. Wires and cables must be free of corrosion. Wires and cables must have cable support clamps in order to prevent stress on battery connections (terminals).
Leads, junctions, switches, and panel instruments that have direct relation to the charging circuit provide correct circuit control.
Inspect the drive components for the charging unit in order to be sure that the components are free of grease and oil. Be sure that the drive components have the ability to operate the charging unit.
Caterpillar parts catalog:
Parts tube Caterpillar catalog:
2P2697
TUBE AS-AIR VENT
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 215, 235B, 3304, 3304B, 3306, 3306B, 515, 518C, 525, 545, 572G, 572R, 615C...
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 215, 235B, 3304, 3304B, 3306, 3306B, 515, 518C, 525, 545, 572G, 572R, 615C...
6K8858
TUBE AS-FRONT-LH
814, 815, 966C, 966R, D379
814, 815, 966C, 966R, D379
7K3272
TUBE AS
814, 815, 966C, 966R, D379
814, 815, 966C, 966R, D379
8S0211
TUBE (Inlet 17.19" Long)
941, 950, 951B, 966C, 977K, D4D, D6C
941, 950, 951B, 966C, 977K, D4D, D6C
2P6229
TUBE ASSEM.
120G, 130G, 518, 528, 930, 930R, 950, 950B, 950B/950E, 966C
120G, 130G, 518, 528, 930, 930R, 950, 950B, 950B/950E, 966C
7W7098
TUBE AS-DRAIN
140B, 140G, 966C, D5B, D6D
140B, 140G, 966C, D5B, D6D
5S9150
TUBE ASSEM. (25.36" Long)
966C, 980B, D6C
966C, 980B, D6C
4N4137
TUBE ASSEM.
941, 950, 955K, 955L, 966C, D4D, D6C
941, 950, 955K, 955L, 966C, D4D, D6C
6K8861
TUBE ASSEM.
814, 815, 966C, 966R
814, 815, 966C, 966R
6K8026
TUBE ASSEM. (54.62" long overall)
814, 815, 966C
814, 815, 966C
9K2857
TUBE (46.04" Long)
814, 815, 816, 966C
814, 815, 816, 966C
7K0621
TUBE ASSEM.
814, 815, 816, 966C
814, 815, 816, 966C
8S6380
TUBE ASSEM. (44.89" long overall)
814, 815, 816, 966C
814, 815, 816, 966C
4K9928
TUBE ASSEM.
966C
966C
4K9918
TUBE ASSEM.
966C
966C
8K5809
TUBE ASSEM.
966C
966C
7K1429
TUBE ASSEM.
966C
966C
7K1489
TUBE ASSEM.
966C
966C
7K8890
TUBE ASSEM.
966C, 966R
966C, 966R