TUBE 7N3115 - Caterpillar

Table 73
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key in order to set the brightness of the rear view camera imagebetween "0" and "22".
Press the OK key. "Brightness (Night)"
The "BRIGHTNESS (NIGHT)" menu allows the operator to adjust the brightness of the rear view camera image for viewing at night.
Table 74
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key in order to highlight the "BRIGHTNESS (NIGHT)" menu. Press the OK key.
Table 75
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key in order to set the brightness of the rear view camera image for viewing at night between "0" and "22".
Press the OK key. Contrast
The "CONTRAST" menu allows the operator to adjust the contrast of the rear view camera image.
Table 76
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key in order to highlight the "CONTRAST" menu. Press the OK key.
Table 77
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key in order to set the contrast of the rear view camera image between "0" and "15".
Press the OK key. Monitor Starting, Switching, and Termination
Monitor Starting
If "VIDEO MODE" is set to "ON" the rear view camera image is displayed when the engine starts.Note: If a warning is detected, the rear view camera image will not be displayed when the engine starts.Monitor Switching From the Rear View Camera Image to the Default Screen
Press any key in order to return to the default display from the rear view camera image.If any of the following conditions are found the monitor will return to the default display automatically:
New warning is found.
The engine coolant temperature gauge reaches level 10.
The hydraulic oil temperature gauge reaches level 10.
The fuel level gauge reaches level 10.Note: When the crane system is active the rear view camera image can not be displayed continuously. Press the OK key in order to display the rear view camera image .Monitor Switching From the Default Screen to the Rear View Camera Image
In order to display the rear view camera image from the default display, press the OK key.Note: This operation is only valid when the default screen is displayed.Monitor Termination
If the rear view camera is displayed and the engine start switch is turned to the "OFF" position, the monitor will terminate after the default display is shown for 3 seconds.If the default display is shown and the engine start switch is turned to the "OFF" position, the monitor will terminate immediately.