TUBE ASSEM. 7V5345 - Caterpillar

Illustration 8 g02586738
Monitor the hydraulic oil temperature on the operator display. Operate the machine until the oil temperature reaches 43 5.6 °C (110 10 °F).
Press home key (12) .
Illustration 9 g02586759
Press down key (13) until "Service" is highlighted on the display screen.
Press OK key (14) .
Illustration 10 g02585659
Press down key (13) until "Calibrations" is highlighted on the display screen.
Press OK key (14) .
Illustration 11 g02586776
Press down key (13) until "Tamper Bar Solenoid" is highlighted on the display screen.
Press OK key (14) .
Illustration 12 g02587837
Press OK key (14) to begin the calibration.
Illustration 13 g02587838
Illustration 14 g02587841
Squeeze trigger (15), and move propel lever (1) to the FORWARD position.
Illustration 15 g02587888
Move tamper switch (16) to the AUTOMATIC position.
Press OK key (14) .
Illustration 16 g02587892
Illustration 17 g02587895
Center Operator Control Station on AS4252C Screed
Rotate tamper speed dial (17) to the MINIMUM position.
Press OK key (14) .
Illustration 18 g02587899
Rotate tamper speed dial (17) clockwise until the speed of the tamper shaft reaches 20 5 rpm.
Press OK key (14) .
Illustration 19 g02587902
Rotate tamper speed dial (17) clockwise until the speed of the tamper shaft reaches 850 25 rpm. Use Tool (A) to measure the speed.
Press OK key (14) .
Illustration 20 g02587906
Rotate tamper speed dial (17) clockwise until the speed of the tamper shaft reaches 1700 25 rpm. Use Tool (A) to measure the speed.
Press OK switch (13) .
Illustration 21 g02587910
Press OK key (14) .
Move propel lever (1) to the NEUTRAL position.
Move throttle control switch (9) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (10) to the OFF position.