TUBE-CORE VENT 9L2916 - Caterpillar

Illustration 18 g02720656
(29) 280-9440 Cushion (31) 8R-3695 Grommet
Slide assembled bracket and cushion (29) through the slot in the top cover. Install 8R-3695 Grommets (31) in the holes in the top cover. Refer to Illustration 18.
Illustration 19 g02720657
(32) 7X-0578 Hard Washer (33) 253-8798 Knob (34) 285-8016 Film
Apply 285-8016 Film (34) to the top cover. Assemble 7X-0578 Hard Washer (32) to 253-8798 Knob (33). Insert the knob through the hole in the cover in order to secure the assembled cushion and bracket. Refer to Illustration 19.
Illustration 20 g02728034
(35) 1S-0994 Clip
Press the fore/aft adjustment knob (E) and collapse the slide. Use 1S-0994 Clip (35) to secure wiring harness (21). Install the clip over the green tape on the harness. Secure the clip to the rear bolt of the bracket. Install the clip at a 15 degree angle. Refer to Illustration 20.Installation of Control and Mounting Group
Illustration 21 g02720659
(36) 314-3472 Spacer (37) 8T-4198 Bolt (38) 8T-4121 Hard Washer (39) 7X-2546 Bolt (40) 8T-5030 Bolt
Attach the assembled support and control to the right side of the seat assembly. Use the bolts, washers, and spacers that were originally removed from the seat. Refer to Illustration 21.
Illustration 22 g02866760
(13) 8T-4224 Hard Washer (35) 1S-0994 Clip (41) 8T-4189 Bolt
Illustration 23 g02728041
Detail F (35) 1S-0994 Clip (42) 346-1069 Plate As (43) 127-2170 Screw (44) 7K-1181 Cable Strap (45) 4P-8134 Clip (46) 3E-4352 Hard Washer
Use two 127-2170 Screws (43) to attach 346-1069 Plate As (42) to the rear of the seat base. Use two 1S-0994 Clips (35), two 127-2170 Screws (43), and two 3E-4352 Hard Washers (46) to secure wiring harness to plate assembly (42). Install the clips over the green tape on the wiring harness. Install 4P-8134 Clip (45) with one 127-2170 Screw (43) and one 3E-4352 Hard Washer (46). Use one 7K-1181 Cable Strap (44) to secure the wiring harness plugs to clip (45). Refer to Illustration 23.
Use one 1S-0994 Clip (35), one 8T-4189 Bolt (41), and one 8T-4224 Hard Washer (13) to secure the wiring harness to the boss on the seat base. Install the clip over the green tape on the wiring harness. Refer to Illustration 22.
Reattach the wiring harness connectors that were detached at location (A) and location (B). Refer to Illustration 1.Joystick Installation Status
Illustration 24 g02966016
Using Caterpillar Electronic Technician (ET), configure the joystick to enable operation.