TURBO GP-BASIC 0R7069 - Caterpillar

(1) Torque for the nut on the pinion flange with 5P3413 Thread Sealant on the threads ... 475 50 N m (350 37 lb ft)(2) Torque for bolts ... 220 30 N m (160 22 lb ft)(3) Torque for nuts (12 each side) and bolts (eight each side) that hold the cover to the case ... 135 15 N m (100 11 lb ft) Apply 9S3263 Thread Lock on the threads of the studs (12 each side) then tighten the studs to a torque of ... 55 10 N m (41 7 lb ft)(4) Apply 9S3263 Thread Lock on the threads of the studs (six) then tighten studs to a torque of ... 30 5 N m (22 4 lb ft)(5) Rubber toric seals and all surface in contact with them must be clean and dry at assembly. Put a thin layer of oil on the surfaces of the metal seals that are in contact just before installation. Put lubricant on all other seals at assembly. Seal rings must be assembled square with the bore and the toric must not be bulged or twisted.(6) Apply 6V6640 Sealant in a 2 to 3 mm (.08 to .12 in) bead along lock centerline and within 5 mm (.2 in) inside bolt holes. Fasten lock to hub within 5 minutes after applying sealant.(7) Torque for nut on the sprocket shaft ... 325 50 N m (240 37 lb ft) To install lock cover, rotate nut clockwise only.(8)