TURBO GP-BASIC 0R7185 - Caterpillar

8. Use tool (B), and remove retaining ring (12) from spool assembly (10).9. Remove washer (14), spring (11) and shims (13) from the spool assembly.10. Use tool (C), and remove retaining ring (15) from spool assembly (10).11. Remove plunger (17), spring (16), and ball (18) from the spool assembly. Step 8 through Step 11 should be repeated for four spool assemblies. Keep the shims (13) with their individual spool for assembly purposes. 12. Remove two bolts (20) and washers. Remove two spring assemblies (19) from the valve. Remove the O-ring seals from the washers.13. Remove the bolt and spring (21) from block (22). Remove the retaining rings, pin and two bearings (23). 14. Remove two bolts (26) and washers.15. Remove bolt (24) and retainer.16. Put identification marks on four plungers for assembly purposes. Remove four plungers (25) and the four springs. 17. Rotate shaft (28), and remove the bolt and washer. Remove shaft (28) from lever assembly (30), spacer (29), washer (27) and the valve body.18. Remove the retaining rings, pin and two bearings from the lever assembly. 19. Remove two bolts (31) and washers from the lever assemblies.20. Remove the key from shaft (33). Use tool (A), and remove the retaining ring and washer (32) from both sides.21. Remove shaft (33) from two lever assemblies (34) and the valve housing.22. Remove the retaining rings, pin and two bearings from the lever assemblies. 23. Remove plug (37).24. Remove three lip-type seals (36) and six roller bearings (38).25. Remove the four bolts and cover (35) and gasket. 26. Remove the bolt from lever (39). Remove shaft (40) from lever (39) and the valve body. Remove lever (39) from the valve body.27. Remove lip-type seal (41) and two bearings from the valve body. 28. Remove seat (43), the two O-ring seals, valve (44), spring (42) and valve (45) from location (X) on the bottom of the valve body.29. If necessary, carefully remove seat (46) from the valve body with a hammer and a punch.Assemble Steering Clutch And Brake Control Valve
1. Inspect O-ring seals and gaskets for damage, and replace if necessary. Make sure the valve bodies and all parts of the valve are clean. Put clean hydraulic oil on all of the parts. 2. Install seat (2), valve (5), spring (1), valve (4) and seat (3) with two O-ring seals into location (X) in the valve body.
When installing the outer bearing in Step 3, use tooling (A) on the stamped end of the bearing only.
3. Use tooling (A), and install the two bearings.4. Put 7M7260 Liquid Gasket Material on the seal bore, and let it dry. Install lip-type seal (8) with the lip of the seal toward the inside of the valve body with tooling (A).5. Put lever (6) into position in the valve body, and install shaft (7) into the valve body and lever (6). Install the bolt and washer into lever (6). 6. Put cover (9) and the gasket in position, and install the four bolts.
When installing