TURBO GP-BASIC 20R0611 - Caterpillar

Starting Above 0°C (32°F)
1. Apply both service brake pedals. 2. Engage the parking brake. 3. Release the service brake pedals. The left service brake pedal will remain in the down position. 4. Move the speed control lever into NEUTRAL. 5. Move the attachment control levers to the HOLD position. 6. Move the governor control lever to low idle. 7. Move the flywheel clutch lever to the brake position and held in place to start the engine. 8. Move the electrical disconnect switch to ON. 9. Push the engine start switch to start the engine. Release the engine start switch when the engine starts.
Do not crank the engine for more than 30 seconds. Allow the starter to cool for 2 minutes before cranking again.
Starting with Jumper Cables
Batteries give off flammable fumes that can explode. Prevent sparks near the batteries. They could cause vapors to explode. Do not allow jump cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump cables.Improper jump procedures can cause an explosion resulting in personal injury.Always connect battery positive (+) to battery positive (+) and battery negative (-) to battery negative (-).Jump only with a battery source and with the same voltage as