TURBO GP-BASIC 20R2729 - Caterpillar

Gauges
Controls - Power Shift
Controls - Direct Drive
Hydraulic Controls - Special Application
Modular Cab Heating & Air Conditioning
Controls
Brake Pedals
Depress brake pedals to stop machine, or to keep engine from overspeeding on down grade. Brake Lock
1. To ENGAGE brake lock: Depress brake pedals and push brake lock lever. 2. To DISENGAGE brake lock: Depress brake pedals and disengage brake lock lever.Steering Clutches
Pull out on steering clutch lever to disengage steering clutch. Release steering clutch lever to engage steering clutch.Decelerator
Push decelerator to override governor control and reduce engine speed. Release decelerator to increase engine speed to governor control setting.Hydraulic Ripper Height Control -
(R) RAISE (H) HOLD (L) LOWERHydraulic Blade Lift
(R) RAISE (H) HOLD (L) LOWER (F) FLOATHydraulic Blade Tilt
(L) LOWER LEFT SIDE (R) LOWER RIGHT SIDE (H) HOLDEngine Governor Control
Pull to just past detent to start engine - push fully forward to stop engine. Pull governor out to obtain desired engine RPM.Winch Control
(N) BRAKE ON(R) BRAKE OFF(I) REEL IN(O) DRUM DISCONNECT(D) DRUM DISCONNECT DETENTTransmission Controls - Power Shift
Transmission Safety Lock
Pull UP on lever to allow shifting of transmission. Push transmission lever to NEUTRAL and push safety LOCK - DOWN to lock transmission in neutral.Transmission Selector Lever
Start engine with transmission in NEUTRAL and safety lock ENGAGED. Release safety lock and move selector lever to desired direction and speed.Transmission Control - Direct Drive
Forward-Reverse Lever
(R) REVERSE DIRECTION(N) NEUTRAL(F) FORWARD DIRECTIONTransmission Speed Lever
Have FORWARD-REVERSE LEVER in NEUTRAL before moving shift lever.
Move lever to desired travel speed.Flywheel Clutch Lever
Pull lever to the REAR to ENGAGE clutch. Push FORWARD to DISENGAGE clutch. Move lever fully FORWARD to ENGAGE flywheel CLUTCH BRAKE.Tool Bar or Dozer - Special Application
(1) FLOAT(2) LOWER(3) HOLD(4) RAISE(5) RAISE DETENT - lever will automatically return to HOLD.No. 2 Valve (Rear Implement)
(1) FLOAT(2) LOWER(3) HOLD(4) RAISE(5) RAISE DETENT - lever will automatically return to HOLD.No. 3 Valve (Rear Implement)
(1) LOWER(2) HOLD(3) RAISE(4) RAISE DETENT - lever will automatically return to HOLD.Heating and Air Conditioning
Controls are on ceiling of operator's compartment.(F)FANTurn to the left for heating: To the right for cooling.(H)HEATINGTurn clockwise for increased heating.(A)AIR CONDITIONINGTurn clockwise for increased cooling. Pressurizing
Turn heating control to OFF.Turn air conditioner switch to OFF.Set FAN switch to LO or HI.Pressurizing the cab provides a clean working atmosphere for the operator. This is useful when heat or air conditioning is not required.Backup Alarm
There is a 3 position switch for volume at the rear of the backup alarm.
(M) MEDIUM(L) LOW(H) HIGHWindshield Wipers
FRONTWINDSHIELD WIPER CONTROL SWITCHESTO OPERATE: TURN KNOB CLOCKWISEREARWINDSHIELD WIPER CONTROL SWITCHTO OPERATE: TURN KNOB CLOCKWISE