1134779 TURBOCHARGER GP Caterpillar parts
3516B
Rating:
Alternative (cross code) number:
CA1134779
113-4779
1134779
CA1134779
113-4779
1134779
Weight: 198 pounds 89 kg.
MARINE AUXILIARY, MARINE ENGINE,
Compatible equipment models: 1134779:
Information:
Check the specific gravity of the coolant solution frequently in cold weather to ensure adequate protection.Clean the cooling system if it is contaminated, if the engine overheats or if foaming is observed in the radiator.Coolant should be drained, the system cleaned and new coolant added every 3000 service hours or two years. When not using Caterpillar Antifreeze and supplemental coolant additive as recommended, the drain period must be shortened to 1500 service hours or one year.Filling at over 20 liters (5 U.S. gallons) per minute can cause air pockets in the cooling system.After draining and refilling the cooling system, operate the engine with the radiator cap removed until the coolant reaches normal operating temperature and the coolant level stabilizes. Add coolant as necessary to fill the system to the proper level.Never operate without a thermostat in the cooling system. Cooling system problems can arise without a thermostat.Refer to Know Your Cooling System, SEBD0518, and Coolant and Your Engine, SEBD0970, for more detailed specifications.Coolant Water
Hard water, or water with high levels of calcium and magnesium ions, encourages the formation of insoluble chemical compounds by combining with cooling system additives such as silicates and phosphates.The tendency of silicates and phosphates to precipitate out-of-solution increases with increasing water hardness. Hard water, or water with high levels of calcium and magnesium ions encourages the formation of insoluble chemicals, especially after a number of heating and cooling cycles.Caterpillar prefers the use of distilled water or deionized water to reduce the potential and severity of chemical insolubility. Using water that meets the minimum acceptable water requirement may not prevent drop-out of these chemical compounds totally, but should minimize the rate to acceptable levels.Antifreeze
Caterpillar recommends that the coolant mix contain a minimum of 30% Caterpillar Antifreeze, or equivalent and acceptable water to maintain an adequate water pump cavitation temperature for efficient water pump performance.Premix coolant solution to provide protection to the lowest expected outside (ambient) temperature. Pure undiluted antifreeze will freeze at -23°C (-10°F).Only use a greater concentration (above 30%) of Caterpillar Antifreeze as needed for anticipated outside (ambient) temperatures. Do not exceed a coolant mixture of 60% antifreeze to water since a concentration above 60% antifreeze will reduce the engine's freeze protection and increase the possibility of deposit formation in the cooling system.
Use Caterpillar Antifreeze or GM Specification 6038-M Antifreeze. Caterpillar Antifreeze is available through your Caterpillar dealer in quantities that follow. Most commercial antifreezes are formulated for gasoline engine applications and will, therefore, have high silicate content. Caterpillar Antifreeze is formulated with a low silicate content and the proper coolant additives for heavy duty diesel engines.GM Specification 6038-M is a low silicate antifreeze, but supplemental coolant additive must be added.The major advantages of Caterpillar Antifreeze are:* Significantly reduces water pump seal leakage problems caused by excessive concentration of chemical additives.* There is no need to add supplemental coolant additive on initial fill which must be done with current commercially available antifreezes.* High silicate antifreezes used with a supplemental coolant additive can cause a
Hard water, or water with high levels of calcium and magnesium ions, encourages the formation of insoluble chemical compounds by combining with cooling system additives such as silicates and phosphates.The tendency of silicates and phosphates to precipitate out-of-solution increases with increasing water hardness. Hard water, or water with high levels of calcium and magnesium ions encourages the formation of insoluble chemicals, especially after a number of heating and cooling cycles.Caterpillar prefers the use of distilled water or deionized water to reduce the potential and severity of chemical insolubility. Using water that meets the minimum acceptable water requirement may not prevent drop-out of these chemical compounds totally, but should minimize the rate to acceptable levels.Antifreeze
Caterpillar recommends that the coolant mix contain a minimum of 30% Caterpillar Antifreeze, or equivalent and acceptable water to maintain an adequate water pump cavitation temperature for efficient water pump performance.Premix coolant solution to provide protection to the lowest expected outside (ambient) temperature. Pure undiluted antifreeze will freeze at -23°C (-10°F).Only use a greater concentration (above 30%) of Caterpillar Antifreeze as needed for anticipated outside (ambient) temperatures. Do not exceed a coolant mixture of 60% antifreeze to water since a concentration above 60% antifreeze will reduce the engine's freeze protection and increase the possibility of deposit formation in the cooling system.
Use Caterpillar Antifreeze or GM Specification 6038-M Antifreeze. Caterpillar Antifreeze is available through your Caterpillar dealer in quantities that follow. Most commercial antifreezes are formulated for gasoline engine applications and will, therefore, have high silicate content. Caterpillar Antifreeze is formulated with a low silicate content and the proper coolant additives for heavy duty diesel engines.GM Specification 6038-M is a low silicate antifreeze, but supplemental coolant additive must be added.The major advantages of Caterpillar Antifreeze are:* Significantly reduces water pump seal leakage problems caused by excessive concentration of chemical additives.* There is no need to add supplemental coolant additive on initial fill which must be done with current commercially available antifreezes.* High silicate antifreezes used with a supplemental coolant additive can cause a
Caterpillar SIS machinery equipment:
Caterpillar SIS
3512B Marine Engine SRH00001-UP »
113-4779
TURBOCHARGER GP
3516B Petroleum Offshore Electric Drilling Engine 9F200001-UP »
113-4779
TURBOCHARGER GP
3516C Petroleum Offshore Electric Drilling Engine 9F400001-UP »
113-4779
TURBOCHARGER GP
3516B Marine Engine 8KN00001-UP »
113-4779
TURBOCHARGER GP
3516B Marine Auxiliary Engine 9AN00001-UP »
113-4779
TURBOCHARGER GP
3512B Marine Auxiliary Engine 8EM00001-UP »
113-4779
TURBOCHARGER GP
3508B Marine Auxiliary Engine 3DM00001-UP »
113-4779
TURBOCHARGER GP
3508B Marine Auxiliary S2A00001-UP »
113-4779
TURBOCHARGER GP
3508B Marine Auxiliary Engine S2B00001-UP »
113-4779
TURBOCHARGER GP
3512B Marine Auxiliary Engine S2G00001-UP »
113-4779
TURBOCHARGER GP
3512B Marine Auxiliary Engine S2H00001-UP »
113-4779
TURBOCHARGER GP
3516B Marine Auxiliary Engine S2P00001-UP »
113-4779
TURBOCHARGER GP
3516B Marine Auxiliary Engine S2R00001-UP »
113-4779
TURBOCHARGER GP
3512C Engine LLB00001-UP »
113-4779
TURBOCHARGER GP
3516B Marine Auxiliary Engine S2Z00001-UP »
113-4779
TURBOCHARGER GP
3516C Petroleum Engine PES00001-UP »
113-4779
TURBOCHARGER GP
3512B Marine Auxiliary ED200001-UP »
113-4779
TURBOCHARGER GP
3512B Marine Auxiliary Engine ED300001-UP »
113-4779
TURBOCHARGER GP
3512B Generator Set ED800001-UP »
113-4779
TURBOCHARGER GP
3512B Generator Set ED500001-UP »
113-4779
TURBOCHARGER GP
3512C Marine Auxiliary Engine ED400001-UP »
113-4779
TURBOCHARGER GP
3516B Petroleum Engine EDJ00001-UP »
113-4779
TURBOCHARGER GP
3516B Petroleum Engine EDH00001-UP »
113-4779
TURBOCHARGER GP
3516B Petroleum Engine EDC00001-UP »
113-4779
TURBOCHARGER GP
3516B Generator Set EDG00001-UP »
113-4779
TURBOCHARGER GP
3516B Generator Set EDP00001-UP »
113-4779
TURBOCHARGER GP
3516C Petroleum Engine EDK00001-UP »
113-4779
TURBOCHARGER GP
3512B Generator Set GS600001-UP »
113-4779
TURBOCHARGER GP
Caterpillar parts catalog:
Parts turbocharger Caterpillar catalog:
4307596
TURBOCHARGER GP
3516B
3516B
1809191
TURBOCHARGER GP
3516B
3516B
1195998
TURBOCHARGER GP
3508B, 3512B, 3512C, 3516B, 3516C
3508B, 3512B, 3512C, 3516B, 3516C
1457997
TURBOCHARGER GP
3516B
3516B
2768957
TURBOCHARGER GP
3516B
3516B
1835175
TURBOCHARGER GP
3516B
3516B
1457093
TURBOCHARGER GP
3508B, 3512B, 3512C, 3516B, 3516C
3508B, 3512B, 3512C, 3516B, 3516C
1457094
TURBOCHARGER GP
3508B, 3512B, 3512C, 3516B, 3516C
3508B, 3512B, 3512C, 3516B, 3516C
1457096
TURBOCHARGER GP
3516B
3516B
1457097
TURBOCHARGER GP
3516B
3516B
1457996
TURBOCHARGER GP
3516B
3516B
2890394
TURBOCHARGER GP
3516B
3516B
3763823
TURBOCHARGER GP
336E, 336E H, 336E L, 336E LH
336E, 336E H, 336E L, 336E LH
3466065
TURBOCHARGER GP
336E, 336E HVG, 336E L, 336E LH, 336E LN, 568 FM LL
336E, 336E HVG, 336E L, 336E LH, 336E LN, 568 FM LL
2751290
TURBOCHARGER GP
C11, TH35-C11I
C11, TH35-C11I
7C7686
TURBOCHARGER GP
3406B
3406B
3320046
TURBOCHARGER GP
777C, 777D, 777F, C32
777C, 777D, 777F, C32
1480803
TURBOCHARGER GP
938G, IT38G
938G, IT38G
3871145
TURBOCHARGER GP
3406B, 3406C
3406B, 3406C
1265046
TURBOCHARGER GP
3406C
3406C