TURBOCHARGER GP 1135340 - Caterpillar

content_table_313029282726252423222120191817313029282726252423222120191817" BORDER="0" WIDTH="493">
Personal injury can result from parts and/or covers under spring pressure.Spring force will be released when covers are removed.Be prepared to hold spring loaded covers as the bolts are loosened.
Remove retaining ring (31), cup (30), spring (29), driven clutch jaw (28), driving clutch jaw (27), bearing (26), washer (25), lockwasher (24), and bolt (23) from drive shaft (17).
Illustration 13 g00925104
Remove retaining ring (32) and bearing (33) from drive shaft (17). Note: Note: Do not reuse retaining ring (32).
Illustration 14 g00925105
Use Tooling (C) to remove lock ring (35). Remove bearing (34) from gear case (6).
Illustration 15 g00925107
Remove spring seat (36) and bearing (37) from drive housing (5).
Illustration 16 g00925110
Remove lip seal (38) from drive housing (5).
Illustration 17 g00925114
To ensure correct assembly, mark the position of cover (39) in relation to motor housing (3). Remove cover (39) and remove the O-ring seal from motor housing (3).
Illustration 18 g00925116
Remove bolt (41) and rotor pinion (40) from the rotor in the motor housing.
Illustration 19 g00925149
Loosen hex socket head bolt (43) and remove rotor clamp nut (42). Remove bearing (44) from rear end plate (45).
Illustration 20 g00925151
Remove O-ring seal (46) and rear end plate (45).
Illustration 21 g00925152
Remove vanes (47) from rotor (48).
Remove rotor (48) from the motor housing.
Illustration 22 g00925156
Use a suitable press to remove bearing (49) and front end plate (50) from rotor (48) as a unit.
Illustration 23 g00925157
Remove bearing (49) from front end plate (50).
Illustration 24 g00925210
Remove washers (51) from front end plate (50).
Illustration 25 g00925216
Remove O-ring seals (52) from rotor cylinder (53).
Illustration 26 g01142915
Remove rotor cylinder (53) from motor housing (3). Remove O-ring seals (54) from the rotor cylinder.