TURBOCHARGER GP 1294906 - Caterpillar

Illustration 1 g00877335
(1) Mode Scroll Switch (2) Increment / Hold / Clear / Store Switch
Illustration 2 g00877621
(3) Submode Number (4) Accepted Symbol (5) Not Accepted SymbolThe calibration of the propel speed dial is performed with the engine OFF. Always perform all of the following calibrations for the propel speed dial: maximum speed and minimum speed.
Turn the key start switch to the ON position. The engine is not started.
Check that the alert indicator for the machine ECM on the Caterpillar Monitoring System is NOT flashing.Expected Result: The alert indicator for the machine ECM is FLASHING.YES - The ECM is reporting a fault at this time. The fault must be corrected prior to performing calibrations. See Troubleshooting, "Diagnostic Code Procedures".NO - The machine ECM is not reporting a fault at this time. Proceed to Step 3.Note: If a service code of CID 950 FMI 13 is present, these procedures may correct the fault. Proceed to Step 3.
Enter the calibration mode (mode 6) of the Caterpillar Monitoring System. In order to enter the calibration mode, press and hold the mode scroll switch (1). Release the switch when "-6-" is showing in the display area.
Enter the submode c04 in order to calibrate the propel speed dial in the MAXIMUM SPEED position. In order to enter this submode, press and hold the Increment / Hold / Clear / Store Switch (2) in the INCREMENT position. Release the switch when submode number "c04" (3) is showing.
Ensure that the propel speed dial is at the MAXIMUM position.
Store the value of the signal that is sent from the propel speed dial sensor. In order to store the value, press and hold the Increment / Hold / Clear / Store Switch (2) in the STORE position. While