TURBOCHARGER GP 1343057 - Caterpillar

Illustration 1 g01118358
Right Pump Flow SolenoidThis diagnostic code is recorded when the ECM reads the current of the right pump flow solenoid as above normal (short to ground).The possible causes of this diagnostic code are:
The signal circuit of the right pump flow solenoid is shorted to ground.
The right pump flow solenoid is malfunctioning.
The ECM has failed. This is unlikely.System Response:The results of this diagnostic code are:
Conveyor diagnostic lamp on the machine operator's station will be ON.
The auger and the conveyor for the right side will not operate.Note: Ensure that the diagnostic code CID 104 FMI F06 for the right pump flow solenoid is on hold and that the diagnostic code present indicator on the ECM display is ON.Test Step 1. Check Right Pump Flow Solenoid
Turn the key start switch to the ON position.
Observe the status of the diagnostic code present indicator on the ECM.
Disconnect the machine harness from the right pump flow solenoid.Expected Result:The diagnostic code present indicator should turn OFF when the right pump flow solenoid is removed from the harness.Results:
OK - The diagnostic code present indicator does turn OFF when the right pump flow solenoid is removed from the machine harness.Repair: The circuit is correct. The right pump flow solenoid is malfunctioning. Replace the right pump flow solenoid. Stop.
NOT OK - The diagnostic code present indicator does not turn OFF when the right pump flow solenoid is removed from the machine harness. Proceed to Test Step 2.Test Step 2. Check Solenoid Circuit For Short To GroundThe machine harness remains disconnected from the right pump flow solenoid.
Turn the key start switch to the OFF position.
Disconnect the machine harness connector from the ECM.
At the machine harness ECM connector, measure the resistance from the signal circuit at connector contact 33 (wire P933-OR) to all possible sources of ground. The possible ground sources are ECM connector contacts 2 and 39.Expected Result:Each resistance should measure greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. Proceed to Test Step 3.
NOT OK - One or more of the resistance measurements is less than 5000 ohms.Repair: There is a short in the machine harness for the right pump flow solenoid circuit. The short is either in the signal circuit (wire P933-OR) or in the return circuit (wire P201-GN) of the machine harness. Repair the machine harness or replace the machine harness. Stop.Test Step 3. Check To See If Diagnostic Code Remains
Clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the key start switch to the ON position.
Enter service mode 1 on the ECM three digit display. Clear all inactive diagnostic codes.
Operate the machine.
Check to see if the CID 104 FMI F06 diagnostic code for the right pump flow solenoid is present (diagnostic code present indicator ON).Expected Result:The CID 104 FMI F06 diagnostic code for the right pump flow solenoid is not present.Results:
OK - The CID 104 FMI F06 diagnostic code for the right pump flow solenoid is not present. The machine harness and the ECM are operating properly.Repair: The initial