TURBOCHARGER GP 1761176 - Caterpillar

Illustration 4 g02594397
Use two people in order to install mount assembly (22). The weight of mount assembly (22) is approximately 25 kg (55 lb). Install bolts (20). Repeat for the opposite side.
Install transmission mounting bolts (21). Tighten bolts (21) and (23) to a torque of 900 100 N m (664 74 lb ft).
Illustration 5 g02594378
Install the yoke and bolt (18). Tighten bolt (18) to a torque of 475 60 N m (350 44 lb ft).
Illustration 6 g02594359
Illustration 7 g02594377
Install tube assembly (17) .
Illustration 8 g02594341
Illustration 9 g02594337
Install tube assemblies (15) and (16) .
Connect hose assemblies (13) and (14) .
Illustration 10 g02594317
Attach a suitable lifting device to secondary steering pump (6). The weight of secondary steering pump (6) is approximately 38 kg (84 lb). Install secondary steering pump (6) and bolts (12) .
Illustration 11 g02594277
Install secondary steering valve (9) and bolts (10). Connect hose assemblies (11) .
Illustration 12 g02594275
Connect hose assembly (8) to secondary steering valve (9) .
Illustration 13 g02594273
Connect hose assembly (7) to the secondary steering pump (6) .
Illustration 14 g02594266
Position hose assembly (3) and clamps (4) and (5) .
Illustration 15 g02594265
Connect hose assembly (3) to the fuel tank.
Illustration 16 g02594263
Connect harness assemblies (2) .
Illustration 17 g02594261
Connect all hose assemblies (1) and the cable strap assemblies to the transmission.End By:
Remove the steering valve.
Remove the center drive shaft.
Remove the rear drive shaft.
Remove the power train guard.
Remove the crankcase guard.
Remove the clean emissions module.
Remove the hydraulic tank.