TURBOCHARGER GP 1912925 - Caterpillar

Table 1
Event Code    
Description    Conditions which Activate the Code    System Response    
E1001(1) High Right Intake Manifold Air Temperature     The inlet air temperature has exceeded the trip point for the programmed delay time.     The code is logged.    
E1001(2) High Right Intake Manifold Air Temperature     The code is logged.
The engine power is derated. Probable Causes
High ambient air temperature
High coolant temperature
High inlet air restriction and/or high altitude
Faulty inlet air temperature sensor and/or circuit
Insufficient flow of cooling water through the aftercooler
Insufficient flow of air through the aftercoolerRecommended Actions
High Ambient Air Temperature
Determine if the ambient air temperature is within the design specifications for the cooling system.Determine the cause of the high air temperature. Modify the inlet air system in order to supply intake air that is within specifications, if necessary.High Coolant Temperature
Check for a high coolant temperature for the engine.Refer to Troubleshooting, "Coolant Temperature Is High".High Inlet Air Restriction and/or High Altitude
When inlet air pressure is low, the turbocharger works harder in order to achieve the desired inlet air pressure. This increases inlet air temperature.Measure the inlet air pressure while the engine is operating under load. For specific data, refer to the Technical Marketing Information (TMI) for your engine.Inlet Air Restriction
Check for plugged air filters. Check for obstructions to the air inlet. Replace the air filters and/or remove the obstruction from the air inlet.High Altitude
Confirm that the settings for the engine are correct for operation at the altitude of the engine installation.Faulty Intake Manifold Air Temperature Sensor and/or the Circuit
Allow the engine to cool. Remove the sensor from the engine. Use Cat ET to check the status of the "Engine Coolant Temperature" parameter. Compare the reading to the ambient air temperature. If the sensor is OK, the readings will be approximately equal.If the readings are not approximately equal, switch the suspect sensor with a sensor that is known to be good. Compare the reading of the good sensor to the ambient air temperature. Replace the suspect sensor, if necessary.Insufficient Flow of Cooling Water Through the Aftercooler
Check the inlet temperature of the coolant for the aftercooler. Compare the reading to the regulated temperature. If the temperature is OK, check the outlet temperature of the coolant for the aftercooler. A high temperature differential indicates an insufficient flow rate.If there is a high differential between the inlet temperature and the outlet temperature of the coolant for the aftercooler, perform the following procedure:
Check the water circuit of the aftercooler for obstructions.
Check the pump for proper operation.Perform the necessary repairs.Insufficient Flow of Air Through the Aftercooler
Determine the pressure differential of the inlet air across the aftercooler. For specific data, refer to the Technical Marketing Information for your engine.If the pressure differential of the air across the aftercooler does not match the specifications, clean the aftercooler.