TURBOCHARGER GP 1912926 - Caterpillar

Engine Rating Parameter
Rating Number
The rating number is the selected rating within a power rating family. The flash file defines the power rating family. The flash file can contain one to four ratings. The rating number defines the power rating that is used within the power rating family.
Table 1
Minimum Maximum Default
1 4 1 Low/High Idle Parameters
Low Idle Speed
The "Low Idle Speed" is the minimum engine rpm.
Table 2
Minimum Maximum Default
700 rpm 1200 rpm 750 rpm High Idle Speed
The "High Idle Speed" is the maximum engine rpm.
Table 3
Minimum Maximum Default
1900 rpm 2900 rpm 2650 rpm ECM Identification Parameter
Equipment ID
"Equipment ID" is the identification of the equipment that is assigned by the customer. The "Equipment ID" is only for reference only by the customer. The "Equipment ID" is not required by the Electronic Control Module (ECM).
Table 4
Value Default
17 digits
The available characters are dependent on the service tool that is being used. Not programmed Miscellaneous
Monitoring Mode Derates
"Monitoring Mode Derates" controls the derate that is associated with the engine monitoring feature. When this feature is enabled and an event code with a "-2" is detected, the engine will be derated.
Table 5
Value Default
Disabled
Enabled Enabled Limp Home Desired Engine Speed
The "Limp Home Desired Engine Speed" is the maximum speed of the engine when the engine has been derated.
Table 6
Minimum Maximum Default
700 rpm 1800 rpm 1200 rpm J1939 Continuous Fault Handling
Remote Torque Speed Control Enable Status
The "Remote Torque Speed Control Enable Status" parameter determines the way that faults will be handled by the ECM when the "J1939 Torque Speed Control (TSC1)" message is used as a speed request input to the ECM. Programming the "Remote Torque Speed Control Enable Status" to "Enabled" will cause the ECM to display a fault code if a valid TSC1 message is not received by the engine ECM within 30 seconds of the engine starting. If the" Remote Torque Speed Control Enable Status" is programmed to "Disabled", the engine will display a 247-12 Data Link Malfunction immediately after a loss of a TSC1 message. Program "Remote Torque Speed Control Enable Status" to "Enabled" if the ECM will always be receiving a TSC1 message.
Table 7
Value Default
Disabled
Enabled Disabled Configurable Inputs
Shutdown Switch Installation Status
A user defined shutdown switch is installed. Programming the "User Defined Switch Installation Status" parameter to "Enabled" notifies the ECM that the input for the shutdown switch is present on pin J1:48. If this parameter is programmed to "Enabled" and the user defined shutdown switch closes, the engine will shut down.
Table 8
Value Default
Installed
Not Installed Installed