2307911 TURBOCHARGER GP Caterpillar parts
735, 740
Rating:
Alternative (cross code) number:
CA2307911
230-7911
2307911
CA2307911
230-7911
2307911
ARTICULATED TRUCK, EJECTOR TRUCK,
Information:
Illustration 1 g01527312
Schematic of the "Hook Free Fall Clutch Solenoid 2" CircuitThis diagnostic code is associated with the "Hook Free Fall Clutch Solenoid 2" for the hook. The FMI 05 means that the ECM has determined that an open in the circuit exists.The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 2952 FMI 05 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire A551-YL) to contact 2 (wire 975-WH).
Observe the status of the FMI 05.Expected Result:The diagnostic code is active. Then, the diagnostic code changes from FMI 05 to FMI 06 as the jumper wire is installed.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The solenoid has failed.Repair: The solenoid has failed. Replace the solenoid. Verify that the new solenoid corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector, measure the resistance from signal contact J1-66 (wire A551-YL) to contact J1-55 (wire 975-WH).Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors. Clean the contacts of the harness connectors and check the wires for damage to the insulation that is caused by excessive heat, corrosion, or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit.
Reconnect all harness connectors in order to make sure that the connectors are fully seated. Also, make sure that the clips for each connector are completely fastened.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 2952 FMI 05 diagnostic code.Expected Result:The CID 2952 FMI 05 diagnostic code is active. Results:
YES - The CID 2952 FMI 05 diagnostic code is active. The diagnostic
Caterpillar SIS machinery equipment:
Caterpillar SIS
735 Articulated Truck B1N00001-UP (MACHINE) POWERED BY C15 Engine »
230-7911
TURBOCHARGER GP
735 Articulated Truck B1N00001-UP (MACHINE) POWERED BY C15 Engine »
230-7911
TURBOCHARGER GP
740 Articulated Truck B1P00001-UP (MACHINE) POWERED BY C15 Engine »
230-7911
TURBOCHARGER GP
740 Articulated Truck B1P00001-UP (MACHINE) POWERED BY C15 Engine »
230-7911
TURBOCHARGER GP
740 Ejector Articulated Truck B1R00001-UP (MACHINE) POWERED BY C15 Engine »
230-7911
TURBOCHARGER GP
735 OEM Articulated Truck WWC00001-UP (MACHINE) POWERED BY C15 Engine »
230-7911
TURBOCHARGER GP
Caterpillar parts catalog:
Parts turbocharger Caterpillar catalog:
1507257
TURBOCHARGER GP
3456, 735, 773B, 773D, 773E, 775B, 824C, 824G, 824G II, 825G II, 826G II, 980G, 980G II
3456, 735, 773B, 773D, 773E, 775B, 824C, 824G, 824G II, 825G II, 826G II, 980G, 980G II
1965946
TURBOCHARGER GP
3456, 735, 773B, 773D, 773E, 775B, 824C, 824G, 824G II, 825G II, 826G II, 844, 980G, 980G II, 990 II
3456, 735, 773B, 773D, 773E, 775B, 824C, 824G, 824G II, 825G II, 826G II, 844, 980G, 980G II, 990 II
2080037
TURBOCHARGER GP
735, 740
735, 740
2082378
TURBOCHARGER GP
735, 740
735, 740
3748293
TURBOCHARGER GP
CX31-C13I
CX31-C13I
3224654
TURBOCHARGER GP
793F, 793F CMD, 793F OEM, 793F-XQ
793F, 793F CMD, 793F OEM, 793F-XQ
1127723
TURBOCHARGER GP
3512B
3512B
6I1695
TURBOCHARGER GP
3306, 3306B
3306, 3306B
2P0983
TURBOCHARGER GROUP--L.H.,R.H.
D348, D349
D348, D349
1377558
TURBOCHARGER GP
3406E
3406E
1063561
TURBOCHARGER GP
G3412, G3412C
G3412, G3412C
3963874
TURBOCHARGER GP
R2900G
R2900G
2534520
TURBOCHARGER GP
C13, CX31-C13I, TH35-C13I
C13, CX31-C13I, TH35-C13I