TURBOCHARGER GP 2373924 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A    138-7573     Link Bracket    2    
B     1U-5750     Engine Stand     1    
C     9U-6238     Guide Bolts     2    
D     5P-3413     Pipe Sealant     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Attach the engine to Tooling (B) .
Illustration 1 g00792659
Install a new gasket (12) on the engine block.
Install Tooling (C) in the engine block.
Illustration 2 g00792654
Fasten Tooling (A) and a suitable lifting device to flywheel housing (11) . The weight of flywheel housing (11) is approximately 86 kg (190 lb). Install flywheel housing (11) on the engine.
Illustration 3 g00792651
Install bolts (10) that hold the flywheel housing in position. Apply Tooling (D) on the four bolts (9) for installation of the housing to the engine block. Remove Tooling (C) and install two bolts (10) .
Illustration 4 g00270422
Tighten the bolts that hold the flywheel housing to the block in the sequence that follows:
In a numerical sequence, tighten bolts 1 through 8 to a torque of 135 14 N m (100 10 lb ft).
In a numerical sequence, tighten bolts 9 through 20 to a torque of 55 7 N m (40 5 lb ft).
In a numerical sequence, again tighten bolts 1 through 8 to a torque of 135 14 N m (100 10 lb ft).
In a numerical sequence, again tighten bolts 9 through 20 to a torque of 55 7 N m (40 5 lb ft).
Illustration 5 g00792650
Install cover (8) .
Illustration 6 g00792643
Install bolts (1) , (2) , (3) , (4) , (5) , and (6) .End By:
Install the air starting motor. Refer to Disassembly and Assembly, "Air Starting Motor - Remove and Install".
Install the crankshaft rear seal and the wear sleeve. Refer to Disassembly and Assembly, "Crankshaft Rear Seal and the Wear Sleeve - Install".
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove and Install".
Install the auxiliary water pump. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Install".
Install the air cleaner housing. Refer to Disassembly and Assembly, "Air Cleaner Housing - Remove and Install".