TURBOCHARGER GP 2514822 - Caterpillar

Removal Procedure
Start By:
Remove the crankshaft front seal. Note: Refer to Specification UENR0995 "Engine Design" for non-specified engine Torque Values.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal.
Illustration 1 g02795275
Disconnect hose assemblies (1) and (2) from the oil cooler.
Illustration 2 g02795251
Remove bolts (4).
Remove front housing (3) and the gasket. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the front housing is clean and free from damage. If necessary, replace the front housing.
Clean all the gasket surfaces of the cylinder block.
Illustration 3 g02864317
Apply liquid gasket to the seam between the lower crankcase section (6) and the upper crankcase section (5).
Illustration 4 g02795251
Align a new gasket and install the gasket to the cylinder block.
Tighten 13 bolts (4) in a side to side sequence. Tighten bolts (4) to a torque of 24 to 27 N m (18 to 20 lb ft)
Illustration 5 g02795275
Connect hose assemblies (1) and (2) to the oil cooler. End By:
Install the crankshaft front seal.
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Fill" for the correct procedure.